F6287
Installation & Operating Instructions for the
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC
www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC.
Used under license by Eileen Grays LLC.
All rights reserved.
Made in
CHINA
FAN INSTALLATION INSTRUCTIONS
1
WARNING
Make sure electricity is turned off at the main power box before commencing work. Turn off the power by removing fuse or turning off circuit breaker before installing the fan and replacing the lamps.
• The lowest point on the fan blade must be at least 2.1 metres (7 feet) from the floor.
• Make sure that ceiling joists are strong enough and of adequate size to support the weight of the fan of about 35 kg.
Fan and hanger bracket must be earthed during installation.
Secure the mounting bracket to the ceiling joist or suitable piece
of timber inserted between the ceiling joists. The bracket should
be attached with two wood screws and washers supplied.
Mounting
Bracket
2
Carefully lift motor assembly onto mounting bracket. Install the
ball joint onto the mounting bracket opening. Rotate fan until
notch on downrod ball engages the ridge on the mounting
bracket. This will allow hands free wiring.
Place remote receiver above hanger ball.
Receiver
GROUND
(Green&Yellow)
AC IN N
(WHITE)
AC IN L
(BLACK)
3
Make the wiring connections for
- signal connector
- receiver’s output connector
- receiver’s input connector
Leave lamp wires connector unconnected for fan without light. Connect live
(AC IN L), neutral (AC IN N) and ground (GROUND) wires to terminal block in
accordance to the wiring label. Isolation switch must be installed.
