Installation & Operating Instructions for the
F6208
Parrotuncle Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Parrotuncle Lighting, 218 Black Tie Lane, Chapel Hill, NC
www.parrotuncle.com
Parrot Uncle YOU CAN BE SURE OF are trademarks of Eileen Grays LLC.
Used under license by Eileen Grays LLC.
All rights reserved.
Made in China
Changing the Downrod (Optional)
NOTE: Your fan comes with a 4”(10cm) downrod attached to the hanger ball. In addition, a 10”(25cm) downrod
has been provided to be used in case the ceiling is lower. In this case, perform the following steps for correct
installation:
1. Remove the hanger ball from downrod by loosening the setscrew at the top of the downrod which holds the
hanger ball to the downrod.
2. Slide the hanger ball down the downrod and remove the support pin.
3. Insert the support pin in the holes at the top of the 4”(10cm) downrod and slide the hanger ball up the
4”(10cm) downrod. Make sure the support pin is properly seated in the grooves in the top of the hanger ball.
4. Tighten the set screws firmly .
INSTALLING THE DOWNROD
When hanging the Fan REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
1) Remove the bolt, lock pin and set screws from the top of the housing assembly
2) Route wires exiting from the top of the fan motor through the bolt&pin cover, decorative canopy cover ,
canopy and then through the ball / downrod.
3) Align the holes at the bottom of the downrod with the holes in the coupling on top of the top housing .
4) Carefully insert the Bolt through the holes in the Coupling and downrod. Be careful not to jam the Bolt against
the wiring inside the downrod. Insert the locking pin through the hole near the end of the Bolt until it snaps
into its locked position.
5) Tighten two set screws on top of the fan housing firmly
INSTALLING THE LIGHT KIT AND BLADES
1.Remove the pre-assembled screws and washers from the blade bracket
for later use.
2.Insert blade into the slot on flywheel. Install blade with screws and
washers that were removed earlier, aligning each of the holes and tighten
all screws securely. Repeat this process for remaining blades.
3. Make the electric connections. Please refer to the Section ‘MAKE THE
ELECTRIC CONNECTIONS’
4. Install the light pan to the base plate by using the two screws that pre-
assembled on the base plate.
5. Raise and hold the light shade close to the light pan, install the light
shade to the light pan by 4 screws that pre-assembled at the side of the
light pan. Tighten all screws securely.
INSTALLING THE FAN TO MOUNTING BRACKET ON
CEILING
WARNING: To avoid possible electrical shock, be sure electricity is turned off at the main
fuse box before wiring.
USING YOUR CEILING FAN
REMOTE CONTROL
Turn on the power and check the
operation of the fan
1 –Fan Shutdown
2 – Speed Controlle
3 – Lamp Switch
4 - Timer (2H,4H,8H)
Reverse function
Slide the forward/reverse switch on
the coupling to get desired airflow
direction.
1.
Install the hanger ball end of downrod into mounting bracket opening. Align (engage) slot
on ball with tab on mounting bracket. Warning: Failure to align slot on ball with tab may
result in serious injury.
2.
Slide the canopy up to ceiling and align the keyhole slots on the canopy with the
preassembled screws on the hanger bracket. Twist clockwise untill it locks. Tighten the two
screws securely.
3.
Attach the decorative canopy cover to the bottom of the canopy by pressing it until it locks.
