F4
5
03
Installation & Operating Instructions for the
Owner’s Installation ,Manual
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
INSTALL THE DOWNROD
Changing the Downrod (Optional)
NOTE: Your fan comes with a 25cm downrod attached to the hanger ball. In addition, a 10cm downrod has
been provided to be used in case the ceiling is lower. In this case, perform the following steps for correct
installation:
1. Remove the hanger ball from downrod by loosening the setscrew at the top of the downrod which holds
the hanger ball to the downrod.
2. Slide the hanger ball down the downrod and remove the support pin.
3. Insert the support pin in the holes at the top of the 10cm downrod and slide the hanger ball up the 10cm
downrod. Make sure the support pin is properly seated in the grooves in the top of the hanger ball.
4. Tighten the set crews firmly .
Safety Cable Installation
For Canadian installation and for USA fan and light kit combinations over 35 lbs, the safety cable must be installed into the house structure beams. Make sure that when the safety cable is fully
extended the lead wires are longer than the cable and no stress is placed on the lead wires. Note: If Installing The Secondary Support Safety Cable in the U.S., Do Not Remove Knockouts In The
Outlet Box.
Hanging the Fan REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
1) Remove the bolt, lock pin and set screws from the top of the housing assembly
2) Route wires exiting from the top of the fan motor through the coupling cover, canopy and then through the ball / downrod.
3) Align the holes at the bottom of the downrod with the holes in the coupling on top of the top housing .
4) Carefully insert the Bolt through the holes in the Coupling and downrod. Be careful not to jam the Bolt against the wiring inside the downrod. Insert the locking pin through the hole near the end
of the Bolt until it snaps into its locked position.
5) Tighten two set screws on top of the fan housing firmly
INSTALLING THE FAN TO MOUNTING BRACKET ON CEILING
1.Install ball end of downrod into mounting bracket opening. Align
(engage) slot on ball with tab on mounting bracket. Warning: Failure
to align slot on ball with tab may result in serious injury.
2.Slide the canopy up to ceiling andalign the keyhole slots on the
canopy with the preassembled screws on the hanger bracket. Twist
clockwise till lock. Tighten two screws securely.
USING YOUR CEILING FAN
REMOTE CONTROL
Turn on the power and check the operation of the fan
.OFF –Fan Shutdown
.HI, MED,LOW – Speed Controller
.LIGHT – Lamp Switch
