+ DC 24V
+ DC 24V
[email protected] www.parmida.com
INSTALLATION GUIDE
24V COB LED STRIP LIGHT
PLED-CSTR27K-24V-20FT PLED-CSTR3K-24V-20FT PLED-CSTR4K-24V-20FT PLED-CSTR5K-24V-20FT PLED-CSTR6K-24V-20FT
INSTALLATION
PACKAGE CONTENTS:
1 x 20 ft COB strip light, 1 x clip connector, 1 x 1pcs
extension 10mm length wire clip.
INSTALLATION:
Ensure the surface is clean, dry, and smooth before
installing the Strip light.
Remove adhesive backing from strip then press firmly into place, smoothing
the adhesive strip against the installation surface.
CUTTING THE STRIP LIGHT:
If you choose to cut the LED Strip Light,
ensure the Strip Light is disconnected from power source before cutting the
strip.
Carefully cut the LED Flex strip where shown by the dashed line. Failure to
cut the strip along the dashed line could result in injury or product damage.
This Strip Light can only be cut every 2 in.
LINKING ACCESSORIES – CLIP CONNECTOR:
If you choose to link the
LED Strip Lights, attach the Strip Lights using the clip connector accessory.
Insert each end of the connecting Strip Lights into the clip as shown –
positive terminal to positive terminal. Press the top of the clip down firmly to
secure the connection.
LINKING ACCESSORIES – EXTENSION WIRE CLIP:
If you choose to link
Strip Lights, attach the Strip Lights using the extension wire clip. Match
positive terminal to positive terminal. Press the top of the clip down firmly to
secure the connection.
POWER CONNECTION:
Power supply is not included. This product must
be powered by a power supply which meets the following specifications:
(Input:100-240vac; Output: 24VDC/3A adapter with male DC connector)
VOLTAGE DROP:
Voltage drop is the normal loss of voltage that occurs as
current flows along a wire connection in low voltage systems which can lead
to a gradual lower lumen output, and general reduction in light quality. Wire
length, thickness, and wattage can influence the amount of voltage drop that
occurs. If connecting multiple Strip Lights, connecting more than 22.96 ft
is not recommended due to voltage drops that lead to gradual lower lumen
output along the Strip Light.
CUTTING THE
STRIP LIGHT
CLIP CONNECTOR
EXTENSION WIRE CLIP
LED ELEMENTS
AND DIFFUSER
EXPOSED POWER
TERMINALS
IMPORTANT:
When using electrical equipment, basic safety precautions should always be followed as below:
READ AND FOLLOW BELOW SAFETY INSTRUCTIONS
1. To reduce risk of electric shock, turn off power before installation or servicing.
2.
This luminaire must be installed in accordance with local and National Electrical Code (N.E.C). If you are not familiar with these codes and requirements
please consult a qualified electrician.
3.
Verify the availability of necessary tools and incidental materials.
4. A 24V DC isolated power supply must be used to operate the LED Strip Light. This product must be powered with a compatible Class 2 DC Constant
Voltage LED Driver (power supply).
5. To avoid damaging the Strip Light, do not bend the Strip Light past a diameter of 60 mm or less.
6. The Strip Light must be handled with care. Excessive handling, bending, and pressure may damage the product.
7. Always disconnect the LED Strip Lights from the power source before cutting or connecting.
UNPACKING:
Thoroughly inspect the light for freight damage. Freight damage should be reported to the delivery carrier
+ DC 24V
+ DC 24V
+
+
–
–
–
+ DC 24V
+
+
+
–
–
–
–
PRESS
COVER
CLOSED
PRESS
COVER
CLOSED
CUT LOCATIONS
