It can remove the water which is left in the tub because of manufacturer’s checking out.
1. Sort the laundry by colour and by care label. Most garments have a
textile care label in the collar or side seam.
2. Make sure all the pockets are empty, Foreign objects (e.g. nails, coins,
paper clips, etc.) can cause damage to garments and components in
the machine.
3. Close any zips, fasten hooks and eyes etc before washing.
4. Dark textiles often contain excess dye and should be washed separately
several times before being included in a mixed load. Always wash whites
and coloureds separately.
5. Badly soiled areas, stains etc. should be pre-treated with liquid detergent,
stain removers etc.
6. Turn over the clothes which pill easily and is with woolen surface before
putting them into the machine.
Unfold the laundry and load loosely in the drum. Mixing both large and small items gives better
wash results and also helps distribute the load evenly during spinning.The most efficient use of
energy and water is achieved when a full load is washed.However, do not overload as this causes
creases and reduces cleaning efficiency.
Make sure that no garments are caught between the
door and the seal.
1.Connect the power and turn on the tap.
2.Turn the knob to position “Standard”.
3.Press “Start/Pause”.
1.Connect the inlet hoses well and turn on the tap.
2.After making sure the power socket is grounded reliably, insert the power plug into the power socket.
3.Place the drain hose well.
Before washing clothes for the first time, you must run a complete cycle without clothes.
To do these:
How to ust washer
Use process
Use process
How to ust washer
1.Turn on the water tap, and connect the power.
2.Open the door, and put the cloth into the drum one by one.
3.Close the door, and put suitable amount of detergent and fabric softener into the dispenser, then
close the drawer.
4.Choose a programme you need by
turning the
knob
.
5.Press the “Temp” button and select a wash temperature.
6.Press “ Start/Pause” button to start the washing machine.
7.When the cycle is finished, there is a warning tone sounds.
It is recommended to use low foaming powder for all washing temperature programs.
When washing cycle is finished, the machine will change into a standby mode.
And the machine will be sleeping after 10 minutes without any control on the
control panel.
1. Open the drawer and add adequate detergent into main wash compartment marked “
” or “
”.
2. Add the fabric softener into compartment marked “ ” or “ ” .
Do not exceed the maximum level mark.
3. Add the detergent into the pre-wash compartment marked “ ” or “ ”
according to the programme you select.
4. Close the drawer.
The right amount to dispenser will depend on the following:
The quantity of laundry
The soiling level of the laundry
-
Lightly soiled
No visible dirt or stains. Possibly
slight body odour.
-
Normally soiled
Visibly dirty and/or just a few slight
stains.
-
Heavily soiled
Visible dirt and stains and/or dried on
soiling.
The water hardness level.
Main wash compartment
Fabric softener compartment
Pre-wash compartment
9
