Parmco PTD-F7-W Скачать руководство пользователя

Страница: 9 / 14

Extra

Anti-Bac

Note :

All the above data in the table came out base on “ ” which tested according to En61121:2013

standard. These data may be different because of different laundry type, residual moisture, environmental
conditions and voltage fluctuation.

Important:

or installation, a charge will be made even if the appliance is under guarantee.

If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use

Ecological hints

This guarantee does not cover

Marking explanation

CE marking

Volt

Tested safety

Watt

Hertz

Alternating current

risk of fire

The materials marked with the symbol are recyclable.

>PE<=polyethylene

>PS<=polystyrene

>PP<=polypropylene

This means that they can be recycled by disposing of them properly in appropriate collection containers.

Old machine

Use authorized disposal sites for your old appliance. Help to keep your country tidy!

The symbol on the product or on its packaging indicates that this product may not be treated as

Packaging materials

Do not over-dry laundry,this avoids creasing and saves energy.

Select the drying programme according to the type of laundry and the required degree of dryness.

Clean the filters regularly to avoid excessive drying times and high electricity consumption.

Ventilate the room well.

Control Manipulate

CN3

CN4

CN1

CN2

S1
S2

SW1

Guide

sensor

Temperature

sensor

PCB

Thermal

Heater

Thermal

GND

Capacitance

COM

GND

drying, the tumble dryer will expel a certain amount of warm, very moist air, and this should be removed from the
room as quickly as possible to prevent condensation. In an extremely well ventilated room or close to an
open window, this may occur naturally. However, in general, it is better to carry the dryer’s exhaust outside
via the vent hose supplied with the appliance; ending either temporarily at an open window, or permanently
at a fixed ventilation grille, fitted to an exterior wall or window.
The tumble dryer must be installed in a clean place, where dirt does not build up. Make sure there are no
obstructing items or material near the air-intake louvres provided at the back(e.g.paper,rags etc). To keep
vibration and noise to a minimum when the dryer is in use, it should be placed on a firm, level surface.

It is recommended that, for your convenience, the machine is positioned close to your washing machine. Whilst

the machine should not move up and down at all.(please check
both of two directions) if the machine rocks when pushing the
machine top plate diagonally, adjust the feet again.

When pushing down the edges of the dryer top plate diagonally,

Important:

must there not be installed in floors which are not resistant to high temperatures.

The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The appliance

note of the model, serial number and purchase date of your machine: the Service Center will require this
information.

If you are unable to identify or solve the problem, contact our service center. Before telephoning, make a

   Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Center, please carry out the
checks listed below.
   During machine operation it is possible that the Start/Pause pilot light flashes to indicate that the
machine is not  working. Once the problem has been eliminated, press the Start/Pause button to restart
the programme, If after all checks, the problem persists, contact your local Service Center.

The "End" light and "Filter" light
are lighting for long time after
the program is finished, the light
are indicating end user to clear
the filter.

You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or
maintenance work.

Use only soap and water and then dry thoroughly.
Important: do not use methylated spirit, diluents or
similar products.

Clean periodically the interior
part of the door to remove
any fluff. Accurate cleaning
ensures correct drying.

wood or similar. This might cause heat build-up which would interfere with the operation of the appliance.

The feet must nevet be removed. Do not restrict the floor clearance through deep pile carpets, strips of

To simplify the installation, there is a choice of vent outlets: one at the back, the other in the left hand side.

Connect the hose to whichever is the more convenient by pulling the ring nut (A)from the vent outlet at the
back, aligning arrows of hose and ring nut, fastening by screwing hose to the direction of arrow and pushing it
firmly back into place. The unused vents should now be sealed with the special snap cover(B)provided.

Advice:
If the hose is long and the room temperature low, the moisture might condense inside the
hose. This is an unavoidable natural phenomenon. To prevent this water from lying in the
hose or flowing back into the tumble dryer, it is advisable to drill small hole (dia.3 mm) in
the lowest point of the hose and to place a small container below it. (See picture, point B) .
Once connected to the dryer, run the vent hose to the desired outlet point, it contains
no more than two bends. As to the outlet itself, if you have decided on a fixed
wall/window grille, a good local builder’s merchant should be able to supply you with
the necessary fittings and installation advice.

It is important not to connect the vent hose to, for example, a cooker hood, or a chimney or flue pipe
designed to carry the exhaust from a fuel burning appliance.
Note that to avoid condensation problems, it is essential that the dryer be fitted with the flexible hose to carry
its auste outside the kitchen.
In order to prevent the appliance from overheating, it is important that the steam exhaust is unobstructed.
If the dryer is fitted next to kitchen units, make sure that the vent hose is not squashed. If the hose is partially
squashed, drying efficiency will be reduced, resulting in longer drying times and higher energy consumption.
If the hose is completely squashed, the safety cut-outs with which the machine is fitted may operate.

Electrical connection
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent
person.

The manufacturer declines any liability should this safety measure not be observed.

Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance’s
rating plate.
Should the plug need to be replaced for any reason, proceed as described below.
The wires in the mains lead are coloured in accordance with the following code:

The wire coloured green and yellow must be connected to the terminal marked with the letter or by the
earth symbol or coloured green and yellow.

A cut off plug inserted into a socket is a serious safety (shock) hazard.
Ensure that the cut off plug is disposed of safely.
Permanent connection

Warning

In the case of permanent connection it is necessary that you install a double pole switch.
The switch must not break the yellow and green earth cable at any point.

household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical

and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential

negative consequences for the environment and human health, which could otherwise be caused by

inappropriate waste handling of this product. For more detailed information about recycling of this product,

please contact your local council, your household waste disposal service or the shop where you purchased

the product.

The Symbol mean: caution, risk of fire Oil-affected items can ignite spontaneously, especially when

exposed to heat sources such as in a tumble dryer. The items become warm, causing an oxidation reaction

in the oil. Oxidation creates heat. If the heat cannot escape, the items can become hot enough to catch fire.

Piling, stacking or storing oilaffected items can prevent heat from escaping and so create a fire hazard. If it

is unavoidable that fabrics that contain vegetable or cooking oil or have been contaminated by hair care

products be placed in a tumble dryer they should first be washed in hot water with extra detergent - this

will reduce, but not eliminate, the hazard.

To save energy and to help protect the environ ment, we recommend that you follow these hints:
Try to load the maximum capacity of the machine as small loads are uneconomical.

or removable parts of glass or plastic.
Appliances found to be in use within a commercial environment, plus those which are subject to rental
agreements.
Products of our manufacture which are not marketed by us.

Damage or calls resulting from transportation, improper use or neglect, the replacement of any light bulbs

Oil-affected items can ignite spontaneously, especially when exposed to heat sources such as in a tumble

dryer. The items become warm, causing an oxidation reaction in the oil. Oxidation creates heat. If the heat

cannot escape, the items can become hot enough to catch fire. Piling, stacking or storing oil-affected items

can prevent heat from escaping and so create a fire hazard. If it is unavoidable that fabrics that contain

vegetable or cooking oil or have been contaminated by hair care products be placed in a tumble dryer they

should first be washed in hot water with extra detergent - this will reduce, but not eliminate, the hazard.

If the weight of the laundry is less than 1 kg, it is more efficient to dry to select

"Time controlled Drying" programme.

7kg

4kg

7kg

3kg

7kg

1.5kg

595*555*850

Power(left-on mode)(W)

Power(off mode)(W)

Energy consuption at full load(kWh)

Programme time at full load(min)

Information on the electrical connection is given on the rating plate

Electrical connection Voltage-Overall
power-Fuse

Depth with loading door open (mm)

Dimensions(W*D*H) (mm)

Dryer

Model

Dry Capacity (kg)

PTD-F7-W

7.0

1030

0.42

5.75

217

To change a programme which is running, first cancel it by turning programme selector dial to “off ”.

Select the new programme and press the “Start” button.

Modifying the programme

Never tumble dry the following :Particularly delicate items such as net curtains ,woolen ,silk ,fabrics with metal trim,
nylon tights ,bulky materials such as anoraks ,blankets, eiderdowns, sleeping bags, feather quilts and any items
containing rubber foam or materials similar to rubber foam .
Always follow the instructions on garment labels:

Recommended loads are indicated in the program charts :
General rules:

Cotton ,linen :

drum full but not too tightly packed ;

Synthetics :

drum no more than half full ;

Delicate fabrics and woollens :

drum no more than quarter full.

Try to load the maximum capacity of the machine as small loads are uneconomical .

Close pillowcases and covers with fasteners to prevent small laundry items getting tangled inside
Close press studs, zips and hooks and tie belts and apron strings. Sort laundry according to type and
degree of drying required.
Do not over-dry laundry, this avoids creasing and saves energy.
Avoid drying dark clothes with light coloured fluffy items such as towels as they could attract the fluff.
The laundry must be thoroughly spun before tumble drying.
Easy-care items, too, e. g. shirts, should be briefly pre-spun before drying.
Knitted textiles(knitted underwear) may shringk a little during drying. Please do not over-dry items of this
type. It is advisable to allow for shrinkage when choosing the size of new purchases.
You can also put starched items into your dryer.However, to achieve the desired starched effect, choose
the programme “Iron dry”.To remove any starch residues, wipe out the internal drum after drying with a
moist cloth and then rub it dry.
To avoid a static charge when drying is completed, use either a fabric softener when you are washing the
laundry or a fabric conditioner specifically for tumble dryers.
Remove the laundry when the dryer has finished drying .
If individual items are still damp after drying ,set a brief post-drying time ,but at least 30 minutes,
This will be necessary particularly for multilayered items (e.g. collars ,pockets ,etc.)

them.

Button up pillowcases ,close zip fasteners ,hooks and poppers. Tie any belts or long tapes. To avoid laundry becoming
tangled:
Close zips ,button up duvet covers and tie loose ties or ribbons(e.g.of aprons). Turn items with double-layered
fabrics inside out(e.g.with cottonlined anoraks ,the cotton layer should be outermost) .These fabrics will then dry better .
Remove all objects from pockets such as lighters and matches .