9
10
Water-tank
Cleaning the condenser
This appliance must be earthed. In case of failure or damage, earth can provide a minimum resistance to
reduce the possibility of electric shock. The power cord has grounding wire with device and power cord
with plug. Plug must be inserted into a properly installed and grounded socket(in accordance with all local
rules and standards).
Caution
!
Before use the machine, the packaging foam must be removed from the drum.
1.Open the loading door.
2.Pull off adhesive strips from inside machine on top of drum.
3.Remove the two packaging foam from the machine.
Removing transport safety packaging foam
Water discharge
Earth note
two packaging foam
It is dangerous to alter the specifications or
attempt to modify this product in any way.
Care must be taken to ensure that the appliance
does not stand on the electrical supply cable.
Any electrical work required to install this
appliance should be carried out by a qualified
electrician or competent person.
Should the appliance be moved, it must be transported vertically.
drainpipe
manual
Quantity
Check accessory:
Open the accessory bag
and check the accessories.
IMPORTANT: The appliance must not bulit-in.
Unpacking:
All packing, must be removed
before using the appliance.
note of the model, serial number and purchase date of your machine: the Service Center will require this
information.
If you are unable to identify or solve the problem, contact our service center. Before telephoning, make a
Drum
light
does
not
work(option)
It’s not necessary to discharge the condensed water to the tank, it can be drained out directly.
change drainpipe
Pull out the water pipe by means of the arrow direction ,Then install
the drainpipe.
Such as the pilers can be used if it is difficult to do.
Water container collects all of the water from condenser.
Water container need to be emptied after every drying
cycle. If the water container is full, an active programme
will break off automatically. the light will comes on
and the buzzer sounds. In order to continue the
programme, the water container must first be emptied.
Water container emptied
1.Pull out water container
3.Pull the water container
in dryer
2.Tip water into pool
4.Press the Start/Pause
button
Humidty sensor
In the movement process, this device is used for induction clothing humidity, it means that it
must be carried on cleaning. Major cause of clean is must scour out the calcium oxide boiler
which on the sensor surface up. Clean the sensor in the tumbler (See picture).
Condenser is one of the very important assembly to realize effective drying, Therefore need special attention.
Suggest you clean the condenser three or four times in every year.
1. Open condenser cover
3. Put the condenser under the tap
make water through completely
by clean condenser.
4. According to installation
of opposite direction
2. Move three pieces of lock
rod, pull out the condenser
Certain problems are due to lack of simple maintenance or oversights, which can be solved easily
without calling out an engineer. Before contacting your local Service Center, please carry out the
checks listed below.
During machine operation it is possible that the Start/Pause pilot light flashes to indicate that the
machine is not working. Once the problem has been eliminated, press the Start/Pause button to restart
the programme, If after all checks, the problem persists, contact your local Service Center.
IMPORTANT:
If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or
installation, a charge will be made even if the appliance is under guarantee.
A separate earth is required by some local rules.In that case,you need buy grounding wire,
clips and screws.
Procedure
Power(left-on mode)(W)
Power(off mode)(W)
Energy consuption at full load(kWh)
Programme time at full load(min)
Ambient
temperature
range
(
℃
)
Dryer
Model
2150
40.5
595X630X850
220-240/50
0.48
0.48
6.88
230
5 ~ 35
DR8WCON
9
