PWS 125 F6
■
8
│
GB
│
IE
Special safety instructions for
grinding and abrasive cutting
a)
Use only the grinding accessories approved
for your power tool and the appropriate blade
guard for these grinding tools.
Grinding tools
which are not designed for the power tool cannot
be sufficiently shielded and are unsafe.
b)
Offset grinding discs must be fitted so that the
grinding surface does not protrude over the
edge of the blade guard.
An improperly fitted
grinding disc which protrudes over the edge of
the blade guard cannot be properly guarded.
c)
The blade guard must be securely mounted
on the power tool and adjusted to ensure
maximum safety so that the smallest possible
amount of the grinding tool is exposed to
the operator.
The blade guard is designed to
protect the operator from fragments, accidental
contact with the grinding tool and sparks that
could ignite clothing.
d)
Grinding tools should only be used for the
recommended applications.
For example: never grind with the side sur-
face of a cutting disc.
Cutting discs are de-
signed to remove material with the edge of the
disc. Any lateral application of force on these
grinding tools can lead to a breakage.
e)
Always use an undamaged clamping flange
of the correct size and shape for the selected
grinding disc.
Suitable flanges support the
grinding disc and reduce the risk of disc break-
age. Flanges for cutting discs can be different to
flanges for other grinding discs.
f)
Do not use worn grinding discs from larger
power tools.
Grinding discs for larger power
tools are not designed for the higher rotational
speeds of smaller power tools and can break.
Additional special safety instructions
for abrasive cutting
a)
Avoid any blockage to the cutting disc or
excessive contact pressure. Do not make any
excessively deep cuts.
Overloading the cutting
disc increases the stress and likelihood of jam-
ming or blocking and thus the possibility of a
kickback or a breakage of the grinding tool.
b)
Avoid the area in front of and behind the
rotating cutting disc.
When you move the cut-
ting disc away from yourself in the workpiece,
it is possible, in the event of a kickback, that
the electrical tool will be thrown out directly
towards you together with the rotating disc.
b)
If the cutting disc jams or you stop working,
switch the tool off and hold it steadily in
the workpiece until the disc has completely
stopped turning. Never attempt to pull a ro-
tating cutting disc out of a cut. This could lead
to a kickback.
Identify and remove the cause of
the jam.
d)
Do not switch the power tool back on while
it is located in the workpiece. Allow the cut-
ting disc to reach its full speed before you
carefully continue the cut.
Otherwise, the disc
can jam, jump out of the workpiece or cause a
kickback.
e)
Support boards or large workpieces to re-
duce the risk of the cutting disc jamming and
causing a kickback.
Large workpieces can
bend under their own weight. The workpiece
must be supported on both sides of the disc:
both in the vicinity of the cutting disc and also
at the edge.
f)
Be particularly careful when making pocket
cuts into existing walls or other obscured areas.
The inserted cutting disc may cut into gas or
water pipes, electrical wiring or other objects
that can cause a kickback.
Содержание PWS 125 F6
Страница 3: ...A B 6a...
Страница 4: ...C D I 0 E F...
