Parkside PTS 500 B2, Перевод оригинальной инструкции

Страница: 28 / 112

PTS 500 B2
GB
│
IE
│ 25 ■
e) Do not use a toothed or chain saw blade or
segmented diamond-coated disc with more
than 10 mm wide slits.
Such accessory tools
cause a kickback or loss of control over the
power tool.
f) Avoid cutting disc jams or excessive contact
pressure. Do not make any excessively deep
cuts.
Overloading the cutting disc increases the
stress and likelihood of tilting or jamming and
thus the possibility of kickback or breakage of
the grinding tool.
g) If the cutting disc jams or you stop working,
switch the tool off and hold it steady until the
disc has completely stopped turning. Never
attempt to pull a rotating cutting disc out of a
cut. This could lead to kickback.
Identify and
remove the cause of the jam.
h) Do not switch the power tool back on as long
as it is in the workpiece. Allow the cutting disc
to reach its full speed before you carefully
continue the cut.
Otherwise, the disc may jam,
jump out of the workpiece or cause kickback.
i) Support panels or large workpieces to
reduce the risk of the cutting disc jamming
and causing a kickback.
Large workpieces can
bend under their own weight. The workpiece
must be deposited on both sides of the disc,
namely in the vicinity of the cutting disc and
also at the edge.
j) Be particularly careful when making “pocket
cuts” into existing walls or other obscured
areas.
The protruding cutting disc may cut gas
or water pipes, electrical wiring or other objects
that can cause kickback.
Supplementary notes
Approved cutting disc designs:
Diamond-coated, disc diameter 85 mm, disc thick-
ness max. 1.8 mm
■ Always wear a dust mask!
■ Always wear ear protectors!
Original accessories/auxiliary
equipment
■ Only use the accessories and additional equip-
ment that are specified in the operating instruc-
tions and are compatible with the appliance.
Cutting saw blade (symbols)
Wear ear protectors!
Wear protective glasses!
Wear safety shoes!
Wear protective gloves!
Wear a dust mask!
Not approved for wet grinding!
Approved diameter of tools