10 GB
¾
Before you begin: Check whether
–
the steel cable 14 is wound properly
around the drum 17 and whether
–
the space between coils is less than the
diameter of the cable itself (Fig . D) .
¾
Make sure the steel cable 14 passes the
maximum/minimum length levers 15 16
properly and without touching them (Fig . B) .
Operation
NOTE
u
The product has been outfitted with a
thermostat switch . During operation, it may
stop the motor 3 . The motor can be only
started again once it has cooled down .
Winding/unwinding the cable
(Fig . J)
¾
Winding the cable: Press the control
switch 8 upwards according to the arrow
indication .
¾
Unwinding the cable: Press the control switch
8 downwards according to the arrow
indication .
Lifting loads
¾
Lower the steel cable 14 so you can handle
it comfortably .
¾
Fasten the load to the hook 10 12 . Use
additional bungee cords where necessary .
The load’s centre of gravity must be beneath
the product .
¾
Wind up the steel cable 14 until it is only
taut . Then fully lift the load .
Maximum/minimum length
levers
NOTE
u
The maximum/minimum length levers 15
16 are not intended to regularly stop
the product . Always attempt to stop the
product before it triggers one of these
levers .
Minimum cable length lever
When the steel cable 14 is fully wound up, the
minimum cable length lever 15 will be triggered .
The steel cable cannot be wound up any further . It
can only be unwound .
Maximum cable length lever
When the steel cable 14 is fully unwound, the
maximum cable length lever 16 will be triggered .
The steel cable cannot be unwound any further . It
can only be wound up .
Emergency off switch
(Fig . J)
¾
In case of an emergency, press the
emergency off switch 7 to stop lifting or
lowering operation .
¾
The product is then locked . To unlock the
product, turn the emergency off switch 7
slightly clockwise (in the direction of the
arrow) until it pops out .
Set-up as block and tackle
Setting up the product as a block and tackle
distributes the load to 2 pulleys . This allows twice
the weight to be lifted . However, the maximum
lifting height and speed are reduced by half .
Содержание PSZ 250 A1
