Parkside PSBM 500, Инструкции по эксплуатации и безопасности

Страница: 36 / 51

37 GB/MT
Q
Included items
1 Impact drill PSBM 500
1 Auxiliary handle
1 Depth stop
1 Carry case
1 Operating instructions
Q
Technical data
Nom. voltage: 230 V ~ 50 Hz
Rated power: 500 W
No-load rotational
speed:
max. 3.000 min
–1
Chuck capacity: max. 13 mm
Drilling in steel: max. ø 10 mm
Drilling in wood: max. ø 20 mm
Drilling in concrete: max. ø 13 mm
Protection class:
II /
noise and vibration data:
Values determined in accordance with EN 60745.
The sound pressure level (A-weighted) of the device
is typically 97 dB(A). Uncertainty K = 3 dB. The
sound level while working can exceed 108 dB (A).
Wear ear protection!
Impact drilling in concrete:
max. Vibration emission value
a
h, ID
= 24.2 m / s
2
Uncertainty
K = 2.0 m / s
2
Drilling in metal:
max. Vibration emission value
a
h, D
= 4.7 m / s 2
Uncertainty
K = 1.5 m / s
2
WArnInG! The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified
in EN 60745 and can be used to compare devices.
Different uses of the device give rise to different vibra-
tion levels and in many cases they may exceed the
values given in these instructions. It is easy to underes-
timate the vibration load if the electrical power tool
is used regularly in particular circumstances.
note:
If you wish to make an accurate assessment
of the vibration loads experienced during a particu-
lar period of working, you should also take into
account the intervening periods of time when the
device is switched off or is running but is not actual-
ly in use. This can result in a much lower vibration
load over the whole of the period of working.
General safety advice
for electrical power tools
WArnInG!
read all the safety advice
and instructions!
Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
KEEP ALL THE SAFETY ADVICE AND INSTRUC-
TIONS IN A SAFE PLACE FOR FUTURE REFER-
ENCE! THE TERM “ELECTRICAL TOOL” USED
IN THE SAFETY ADVICE REFERS TO ELECTRICAL
TOOLS POWERED BY MAINS ELECTRICITY (BY
MEANS OF A MAINS LEAD) AND ELECTRICAL
TOOLS POWERED BY RECHARGEABLE BATTER-
IES (WITHOUT A MAINS LEAD).
1. Workplace safety
a) Keep your working area clean and
well lit.
Untidy or poorly lit working areas
can lead to accidents.
b)
Do not work with the device
in potentially explosive envi-
ronments in which there
are inflammable liquids, gases or
dusts.
Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other peo-
ple away while you are op-
erating the electrical tool.
Distractions can cause you to lose control of
the device.
Introduction / General safety advice for electrical power tools
35321_IMPACT DRILL_Content_LB5 new.indd 37 03.09.09 12:02