Parkside PPKS 35 B2, Перевод оригинальной инструкции по эксплуатации и безопасности

Страница: 17 / 64

17 GB/IE
Safety instructions / Handling...
z
Safety instructions
KEEP OUT OF THE REACH OF CHILDREN!
Never attach the magnets to the
plasma cutter itself or its housing.
Before using, please read the oper-
ating instructions for the circle cutter
PPKS 35 B2 and the operating instruc-
tions for the plasma cutter you are
using in full.
It is essential that you observe the
safety instructions of your plasma
cutter!
Check the circle cutter before fitting
it to the plasma cutter. Damaged
components must not be used.
z
Handling the circle cutter
Attach the circle cutter 1 using the magnetic
holder 3 or metal pin 4 (during preparation for
each centre punch) on to the metal surface to be
processed. The plasma torch can now be posi-
tioned in the torch holder with Bakelite inner ring,
as in Figure B
5 . Using the adjusting screws 7
of the spacer 6 you can now set the precise gap
from the plasma torch to the workpiece (Fig. C),
so that the plasma torch is lying flat. Using the