Parkside PPKS 35 A1, Инструкции по эксплуатации и безопасности

Страница: 7 / 56

7 GB
... / Intended use / Package contents
Any use that differs to the intended use as stated
above is prohibited and potentially dangerous.
Damage or injury caused by misuse or
disregarding the above warning is not covered
by the warranty or any liability on the part of
the manufacturer. The device is not intended for
commercial use. Commercial use will void the
guarantee.
KEEP OUT OF THE REACH OF CHILDREN!
z
Intended use
The circle cutters PPKS 35 A1 is designed for use
with the PPS 40 A1 and PPS 40 B2 plasma cutters
from Parkside. You can use the circle cutter to
make circular cuts, the diameter of these cuts can
be continuously adjusted over a range of approx.
15 cm to 60 cm. Centring can be carried out
either using a magnet or metal pin (during prepa-
ration for each centre punch). Please refer to the
operating instructions of the plasma cutter you are
using for information about material thicknesses
which can be cut.
z
Package contents
1 circle cutter PPKS 35 A1
1 set of operating instructions
311378_Kreisschneider_PPKS_35_A1_LB4_V6.indd 7 11.10.2019 08:16:54