Parkside PMFW 280 A1 - 7, Руководство пользователя

Страница: 10 / 65

10 GB/CY
Ensure that there is adequate ventila-
tion when working on plastic, paint,
varnish etc.
Do not soak the materials or the sur-
face you are about to work on with
liquids containing solvents.
Advice on use
Principle of operation:
The oscillating drive causes the attached tool to vi-
brate backwards and forwards up to 21000 times
per minute. This means the tool can produce precise
work in the tightest of spaces.
Sawing / cutting:
Use only undamaged, defect-free saw blades.
Distorted, blunt or otherwise damaged saw
blades could break.
When sawing lightweight building materials,
observe the statutory requirements and the
manufacturer’s recommendations.
Use the device in plunge sawing mode on soft
materials such as wood, gypsum plaster board
etc. only!
Sanding:
Ensure that you use even contact pressure. This
will increase sanding sheet life.
Assembly
Selecting the right tool
Metal saw blade
5
Materials:
Sheet and tube up to approx. 3 mm made of
aluminium, cooper
Use:
· Cutting and trimming to length of tube and sheet
Plunge saw blade
6
Materials:
Wood, plastic, plasterboard and other soft materials
Use:
· Cutting and plunge sawing
· Close to the edge sawing, even in difficult to
access areas
Example: Sawing of recesses in lightweight walls.
Backing plate
7
Materials:
Wood, paint
Use:
· Sanding at edges and in difficult to access areas
Segment saw blade
8
Material:
Wood
Use:
· Cutting and plunge sawing
General safety advice for electrical power tools / Assembly