Parkside PKZ 180 B2, Оригинальное руководство пользователя

Страница: 9 / 49

PKZ 180 B2 ■ 6 │
GB
│
CY
Operation
NOTE
► The appliance vibrates during operation.
Therefore, always put it down during opera-
tion. There are four feet on the bottom of
the appliance for this purpose.
♦ Remove the required accessories from the ac-
cessory compartment .
Switching on and off
Switching the appliance on:
♦ Move the ON/OFF switch into the position
"I" to switch the appliance on. The integrated
control lamp lights up.
Switching the appliance off:
♦ Move the ON/OFF switch into the position
"O" to switch the appliance off. The integrated
control lamp goes out.
CAUTION!
► Caution! This appliance is not designed for
continuous operation.
To prevent the motor
from overheating, the appliance may only be
used as follows: within a period of 10 min-
utes the appliance may only be operated at
the rated power input for 15% of the period,
in other words, 1.5 minutes. During the rest of
the time period (cooling phase 8.5 minutes),
the appliance cools down again.
Compressed air hose with quick coupler
Connecting:
♦ Push the compressed air connector into the
quick coupler of the compressed air hose ,
the sleeve automatically springs forwards.
Cutting:
♦ Pull back the sleeve on the quick coupler of
the compressed air hose and remove the
compressed air connector .
CAUTION!
► Caution! When disconnecting the quick
coupler of the compressed air hose , hold
the coupler firmly to prevent injuries caused
by the hose flying off.
Inflation
with adapter
Schrader valve
Area of use:
This application allows for a simple and accurate
inflation. The manometer is used to check the
tire pressure. Thanks to the integrated release valve
it is possible to reduce the tire pressure if it is
too high.
ATTENTION!
► Please note, the manometer is not cali-
brated! After inflation, always check the tire
pressure immediately, for example, at a petrol
station.
♦ Ensure that the ON/OFF switch is set to "O".
♦ Press the lever quick coupler downwards to
attach it.
♦ Place the lever quick coupler onto the valve
and then release the lever.
♦ Insert the mains plug of the compressor into
a mains power socket.
♦ Switch the ON/OFF switch to "I". The inte-
grated control lamp lights up.
♦ Pull the trigger .
♦ Read the air pressure from the manometer .
♦ Let the trigger off again.
♦ Switch the ON/OFF switch to "O" as soon
as the correct or permissible air pressure has
been reached. The integrated control lamp
goes out.
♦ Press down the lever quick coupler and pull
it off the valve.
♦ Remove the mains plug from the mains
power socket.