Take the blade (7) off the inner flange (40)
and pull downwards and out.
Carefully clean the flange screw (33), outer
flange (34) and inner flange (40).
Fit and fasten the new saw blade (7) in
reverse order.
Important!
The cutting angle of the teeth, in
other words the direction of rotation of the
saw blade (7) must coincide with the
direction of the arrow on the housing.
Before continuing your work make sure that
all safety devices are in good working
condition.
Important!
Every time that you change the
saw blade (7), check to see that it spins
freely in the table insert (11) in both
perpendicular and 45° angle settings.
Important!
The work to change and align
the saw blade (7) must be carried out
correctly.
8.8 Transport (Fig. 1-3)
Retighten the locking grip (13) to secure the
turntable (16) in place.
Activate the release lever (3), press the
machine head (5) downwards and secure
with the safety pin (25). The saw is now
locked in its bottom position.
Fix the saw’s drag function with the locking
screw for drag guide (24) in rear position.
Carry the equipment by the fixed saw table
(17).
When reassembling the equipment proceed
as described under section 7.2.
8.9 Using the laser (Fig. 21-23/Item 35)
To switch on:
Move the ON/OFF switch of
the laser (36) to the “1” position. A laser line
is projected onto the material you wish to
process, providing an exact guide for the
cut.
To switch off:
Move the ON/OFF switch of
the laser (36) to the “0” position.
Setting the laser:
The laser is adjusted
with the screw (39) and glued in place ex-
works. Further adjustment of the laser
during operation is not required. Important.
Do not look into the laser beam.
Replacing the battery:
Switch off the laser
(35). Remove the battery compartment
cover (38). Remove the batteries and
replace with new batteries (2 x 1.5 Volt
Type R03, LR 03 Micro, AAA) Check that
the battery terminals are positioned
correctly when inserting new batteries.
Close the battery compartment (37) again.
9. Replacing the power cable
If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
10. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before
starting any cleaning work.
10.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
We recommend that you clean the
equipment immediately after you use it.
Clean the appliance regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
appliance. Ensure that no water can get into
the interior of the equipment.
10.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important. The carbon brushes should not be
replaced by anyone but a qualified electrician.
10.3 Servicing
There are no parts inside the equipment which
require additional maintenance.
20
GB
Anleitung_LB4_4300688:_ 20.12.2010 10:08 Uhr Seite 20
