Parkside PKGA 20-Li A1, Перевод оригинальной инструкции

Страница: 59 / 100

59
GB MT
Removing appliance attachment
1. Push the unlocking lever (5) into posi-
tion as far as the stop and then
hold it in this position.
2. Pull the unlocked appliance attachment
off (4/17/23/26).
3. Allow the unlocking lever (5) to slide
back into position .
Fitting appliance attachment
4. Push the appliance attachment
(4/17/23/26) along the guide rail
into the motor unit (6). It locks into
place audibly.
5. Allow the unlocking lever (5) to slide
back into position .
6. Check that the appliance attachment is
secure by pulling on it.
Switching on/off
1.
Switching on:
Press the on/off switch
( 11).
By using the on/off switch ( 11) you
can progressively control the speed.
Gentle pressure: low speed
Increase pressure: higher speed.
2.
Switching off:
Release the on/off
switch ( 11).
If you place the direction switch
( 7) in the middle position, the de-
vice is secured against being switched
on.
Motor unit with drill at-
tachment PKGA1
Changing the tool
Secure the appliance against
switching on (see “Switch-
ing on/off”). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Rotate the keyless chuck (1) counter-
clockwise, until the drill chuck aperture
is large enough to accommodate the
tool.
2. Insert the tool as far as possible into
the keyless chuck (1).
3. Rotate the keyless chuck (1) clockwise
in order to clamp the tool.
4. To remove the tool again, rotate the
keyless chuck (1) and pull out the tool.
Choice of gear
Stop appliance before
changing gear.
1. Wait for the appliance to come to a
standstill.
2 Slide the gear selector ( 3) into the
required position:
1: low speed preselection.
2:
high speed preselection.
Set the direction of rotation
The appliance’s direction of rotation can
be changed with the rotational direction
switch.
1. Wait for the appliance to come to a
standstill.
2. Push the rotational direction speed
( 7) into the desired position:
Clockwise rotation:
to drill and
screw in screws.
Anticlockwise rotation:
to un-
screw screws.
3. If you place the direction switch (
7) in the middle position, the device is
secured against being switched on.
The direction change may only be
actuated when at a standstill!