Parkside PISG 80 A1, Руководство по сборке, эксплуатации и уходу

Страница: 12 / 38

12 GB
ATTENTION!
A voltage 10 % below the rated input voltage of
the welding tool may result in:
A drop in the current of the tool.
The arc stopping or becoming unstable.
ATTENTION!
A voltage 20 % above the rated input voltage of the
welding tool may result in:
The safety indicator on the device activating.
The welding tool not working.
The arc radiation may cause inflammation of
the eye and skin burns.
Spray and fusion slag may cause eye injuries
and burns.
Wear tinted eye goggles or a face shield.
The face shield must comply with safety stand-
ard EN175.
Only use welding cables included in delivery
(10 mm
2
).
Welding
Choose from welding with the tool directed towards
the unwelded or the welded part.
The following illustrates how the direction of move-
ment has on the quality of the weld:
Towards the unwelded
part:
Towards the welded part:
Weld penetration less greater
Weld width larger smaller
Welding bead flatter higher
Weld imperfections greater less
Note:
Determine which welding method is more
suitable for yourself after welding a test piece.
Maintenance and Cleaning
Note:
The welding tool requires regular maintenance
and reconditioning to work properly and to comply
with safety requirements. Improper and incorrect
operation may result in malfunctions and damage
the tool.
Switch off the main power supply and the main
switch on the device before maintaining or re-
pairing the welding tool.
Regularly clean the inside and outside of the
welding tool. Remove dirt and dust inside the
device with air, steel wool, or a brush.
Current regulators, earthing equipment, internal
cables, the blowpipe coupler and adjusting
screw should be maintained regularly. Tighten
loose screws and replace rusty screws.
… / Environmental … ... / Information about warranty and service … / Warranty terms Start-up / Welding / Maintenance and Cleaning
270751_Inverter Schweissgeraet PISG 80 A1_content_CZ.indd 12 27.01.16 15:00