Parkside PHKSA 20-Li A2, Перевод оригинальной инструкции

Страница: 12 / 122

PHKSA 20-Li A2 GB
│
CY
│
7 ■
d) Support large panels to minimise the risk of
blade pinching and kickback.
Large panels
tend to bend under their own weight. Panels/
boards must be supported on both side: i.e.
both in the vicinity of the saw cut and also at
the edge.
e) Do not use blunt or damaged saw blades.
Saw blades with blunt or misaligned teeth may
cause excessive friction as the saw cut is too
narrow, and this can cause a saw blade jam
and kickback.
f) Before sawing, ensure that the fastenings
for the cut depth and cut angle settings are
tightened.
If the settings change while sawing,
the saw blade might jam and cause a kickback.
g) Be particularly careful when sawing in
existing walls or other obscured areas.
The
inserted saw blade could get caught on hidden
objects and cause a kickback.
Function of the lower blade guard
a) Check whether the lower blade guard closes
properly before each use. Do not operate
the saw if lower blade guard does not move
freely and close instantly. Never clamp or tie
the lower blade guard into the open position.
If the saw is accidentally dropped, lower blade
guard may be bent. Raise the blade guard with
the release lever and make sure it moves freely
and does not touch the blade or any other part
at all angles and cut depths.
b) Check the operation of the lower blade
guard spring. Have the saw serviced before
using it if the lower blade guard and spring
are not working properly.
Damaged parts,
sticky deposits or accumulations of chippings
can cause the lower blade guard to operate
slowly.
c) The lower blade guard may be retracted
manually only for special cuts such as
"plunge cuts" and "compound cuts".
Raise
the lower blade guard with the release lever
and release it as soon as blade enters the
material.
For all other sawing, the lower blade
guard should operate automatically.
d) Always ensure that the lower blade guard
is covering the blade before placing the
saw down on the workbench or floor.
An
unprotected, coasting saw blade will move
the saw in the opposite direction to the cutting
direction and saw anything in its path. Always,
take into account that the saw blade takes some
time to stop spinning.
Safety guidelines for battery chargers
■
This appliance may be used by
children aged 8 years and above
and by persons with limited
physical, sensory or mental
capabilities or lack of experience
and knowledge, provided that
they are under supervision or
have been told how to use the
appliance safely and are aware
of the potential risks. Do not allow
children to use the appliance as a
toy. Cleaning and user maintenance
tasks may not be carried out by
children unless they are supervised.
■
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for indoor use only.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦ A current list of battery compatibility can be
found at www.lidl.de/Akku.