09
Note! Risk of damage!
• Always switch off the hot glue gun and place it on the integrated stand
even during short breaks.
• Never use the hot glue gun for more than 30 minutes. After this, allow
the hot glue gun to cool down completely before using it again.
Lighting the hot glue gun (Fig. C)
5. Usage
Ignition
Gas supply
open
Inspection glass
2
3
1
• Push the gas supply regulator (4) upwards and turn it to the right using your thumb until the
valve is completely open.
• Now press the piezo ignition (9) immediately.
• Look through the inspection glass (11) to see if the hot glue gun has ignited successfully. If
yes, the heating chamber will be glowing red. The brightness may vary slightly depending
on the level of the gas in the tank and depending on the quality of the gas used.
•
DANGER!
In case the hot glue gun does not ignite successfully after numerous five
attempts, close the gas supply regulator immediately to stop the gas flow and refer to the
"Troubleshooting" chapter.
