11
GB
equipment be returned to
an upright position. For your
own safety, wait approx. 5
minutes before reconnecting
to the electricity.
Ending operation
1. After having worked with a detergent
rinse the pressure cleaner with clear
water.
2. Release the lever of the gun (1).
3. Turn off the pressure by its ON / OFF
switch (10). Disconnect the mains plug.
4. Turn off the water tap.
5. Disconnect the pressure cleaner from
the water mains.
6. Pull the lever of the gun (1) to vent the
pressure existing within the system.
Using detergents
The pressure cleaner was designed for
operation with a neutral detergent based
on a biologically decomposable anionic
tenside. Other detergents or chemical sub-
stances could impair the safety of the pres-
sure cleaner and damage it. Such damage
to the equipment is not covered by the
guarantee.
Fill/drain detergent:
• To add cleaning agent to the jet, you
must first fill the cleaning agent tank
(15).
• To remove the cleaning agent tank
(15), hold it on the side and push it up-
wards. You can now pull the cleaning
agent tank out of the bottom and side
guides on the pressure cleaner. Mind
to first remove the induction hose and
the cap from the opening of the clean-
ing agent tank (14) as they will remain
on the pressure cleaner.
• To reinstall the cleaning agent tank
(15), trace back the above steps.
Working Instructions:
• Operate the standard Vario nozzle
(18) in low-pressure mode to automati-
cally add cleaning agent to the water.
• The rotating wash brush (19) is always
in low-pressure mode and cleaning
agent will thus always be added to the
water.
• To operate the rotating wash brush
(19) without any cleaning agent, re-
move the cleaning agent tank (15).
Cleaning and
Maintenance
Pull out the power plug before eve-
ry maintenance operation. This also
includes connecting to the water
supply or trying to eliminate leaks.
There is a risk of electrocution or of
injury from moving parts.
Cleaning
Never direct the water jet
against the pressure cleaner,
nor clean the pressure clean-
er under flowing water. This
could give rise to the danger
of electric shock and damage
the pressure cleaner!
Always keep the pressure cleaner
clean. Do not use any detergents or
solvents.
• Always keep the ventilation slots clean
and free.
• Only clean the pressure cleaner with a
soft brush or a slightly moist cloth.
• In case a nozzle of the jet tube
(17/18) is clogged up, use the nozzle
cleaning needle (21) to remove the
object from the nozzle.