Parkside PFS 280 A1, Руководство пользователя

Страница: 7 / 58

7 GB
Introduction / General safety advice for electrical power tools Introduction
Q
Technical data
Rated voltage: 230 V∼ 50 Hz
Rated power: 280 W
Spraying capacity: 130 g / min
Paint cup volume: Approx. 600 ml
Air hose: 2 m
Mains lead: 5 m
Protection class: II /
IP rating: IP23
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 50144-2-7:2000. The A-weighted
noise level of the electrical power tool are typically:
Sound pressure level: 78.3 dB(A)
Sound power level:
91.3 dB(A)
Uncertainty K: 3 dB
Wear ear protection!
Evaluated acceleration, typical:
Hand / arm vibration = 0.532 m / s
2
Uncertainty K = 1.5 m / s
2
The vibration level given in these
instructions has been measured in accordance with
a standardised measurement procedure specified in
EN 50144-2-7:2000 and can be used to compare
devices. Different uses of the device give rise to
different vibration levels and in many cases they
may exceed the values given in these instructions. It
is easy to underestimate the vibration load if the
electrical power tool is used regularly in particular
circumstances.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
General safety advice for
electrical power tools
Read all the safety advice
and instructions! Failure to observe the safety
advice and instructions may result in electric shock,
fire and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term “electrical tool” used in the safety advice
refers to electrical tools powered by mains electrici-
ty (by means of a mains lead) and electrical tools
powered by rechargeable batteries (without a
mains lead).
1. Workplace safety
Keep children and other
people away while you are
operating the electrical tool.
Distractions can cause you to lose control of
the device.
2. Electrical safety
The mains plug on the device must match
the mains socket. The plug must not
be modified in any way. Do not use
an adapter plug with devices fitted
with a protective earth.
Unmodified
plugs and matching sockets reduce the risk of
electric shock.
Keep the device away from rain or
moisture.
Water entering an electrical device
increases the risk of electric shock.
Do not use the mains lead for
any purpose for which it was
not intended, e.g. to carry the
device, to hang up the device or to pull
the mains plug out of the mains socket.
Keep the mains lead away from heat,
oil, sharp edges or moving parts of the
device.
Damaged or tangled mains leads
increase the risk of electric shock.