Parkside PFBS 9.6 V - 6, Руководство пользователя

Страница: 12 / 86

13 GB/IE/CY
away or trim them. Loose fastening cords rotat-
ing with the attachment could catch your fingers
or become trapped in the workpiece.
Special safety advice for
working with wire brushes
a)
Bear in mind that wire brushes lose
pieces of wire during normal use. Do
not overload the wires by applying too
much pressure.
Flying pieces of wire can very
easily penetrate thin clothing and / or skin.
b)
Use a guard, if recommended, but
make sure that the wire brush does
not come into contact with the guard.
The diameters of disc brushes and cup brushes
can increase due to contact pressure and cen-
tripetal forces.
Safety advice applicable
specifically to cordless
multi-grinders
When you use the drill / grinder wear
the following protective equipment:
safety glasses and protective gloves.
CAUTION! RISK OF INJURY!
The tool
continues to rotate after it has been
switched off! Avoid contact with rap-
idly rotating drill / grinder components.
WARNING!
Securely support the work-
piece. Use clamps or a vice to grip the workpiece
firmly. This is much safer than holding it in your
hand.
WARNING!
RISK OF INJURY!
Never
support yourself by placing your hands near or
in front of the device or the workpiece surface.
A slip can result in injury.
DANGER OF FIRE FROM FLYING
SPARKS!
Abrading metal creates
flying sparks. For this reason, always
make sure that nobody is placed in any danger
and that there are no inflammable materials
near the working area.
WARNING! DUST HAZARD!
Any
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
WARNING! NOXIOUS FUMES!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
Do not soak the materials or the surface you
are about to work on with liquids containing
solvents.
Avoid abrading paints containing lead or other
substances hazardous to health.
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding
tools.
Do not machine moist materials or damp sur-
faces.
NOTE!
Do not allow the tool to come to a
standstill by overloading it!
WARNING! RISK OF INJURY!
Switch the device off and allow it to come to a
standstill before you put it down.
WARNING!
Always keep the device
clean, dry and free of oil or grease.
Operation
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.
Charging the battery pack
NOTE!
A battery pack that has been
unused for a while or never been charged
must be charged before reuse or first use.
The battery pack requires about 3-5 cycles before
it can reach its full charge.
CAUTION! RISK OF INJURY!
Always pull
out the mains plug (mains adapter
9
) before
General safety advice for electrical power tools / Operation