Parkside PFBS 10.8 A1, Руководство по эксплуатации и безопасности

Страница: 13 / 61

13 GB
General safety advice for electrical power tools / Operation General safety advice for electrical power tools
Avoid abrading paints containing lead or other
substances hazardous to health.
Do not machine materials containing asbestos.
Asbestos is a known carcinogen.
Avoid contact with moving sanding or grinding
tools.
Do not machine moist materials or damp surfaces.
NOTE! Do not allow the tool to come to a stand-
still by overloading it!
RISK OF INJURY! Switch
the device off and allow it to come to a standstill
before you put it down.
Always keep the device clean,
dry and free of oil or grease.
Safety notices for chargers
This appliance can be used by children aged from
8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of
experience and knowledge if they have been giv-
en supervision or instruction concerning use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user maintenance
shall not be made by children without supervision.
The charger is only suitable for
indoor use.
If the mains power cable of this appliance is
damaged, it has to be replaced by the manu-
facturer or its service department or a similarly
qualified person in order to avoid hazards.
Q
Operation
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.
Q
Charging the battery pack
NOTE! A battery pack that has been unused for a
while or never been charged must be charged before
reuse or first use. The battery pack requires about
3–5 cycles before it can reach its full charge. The
charging process takes about 180 minutes.
CAUTION! RISK OF INJURY! Always pull
out the mains plug (mains adapter
10
) before
you insert the battery pack into or take it out of
the charger.
Insert the battery pack
4
into the charging
cradle
9
. This can only be inserted with the
correct polarity.
Connect the adapter
10
to a mains socket.
The red charge level indicator
11
will light up as
long as the battery pack is being charged. Once
charging is completed the red charge level in-
dicator
11
will extinguish and the green charge
level indicator
11 a
will light up. The battery
pack
4
is ready for use.
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Q
Inserting / removing the
battery pack into / out of
the drill / grinder
Inserting the battery pack:
Set the ON / OFF switch
5
to position “0”.
Insert the battery pack
4
into the drill / grinder
until it engages.
Removing the battery pack:
Pressing the battery pack buttons
3
at the
sides at the same time allows you to remove
the battery pack
4
.
Q
Reading off the battery status
The status or residual power is indicated as follows
in the battery-operated LED
2
whenever the appli-
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power