Parkside PDTS 6.3 A1, Инструкции по эксплуатации и безопасности

Страница: 16 / 101

GB/IE/NI
16
Operation
of connecting to the compressed air system, and
tool effectiveness and life is extended as a result.
Connecting sleeve
Compressed air hose
Quick release connector
Compressor
Pressure regulator
Oiler
Filter
Quick release connector
Quick release connector
Before first use and thereafter at regular intervals,
apply a few drops of pneumatic equipment or
motor oil SAE 10-20 into the compressed air
connection on the pneumatic device. After every
3–4 operating hours, use the assembly key to
remove the screw plug
9 in the oil reservoir.
Fill the oil reservoir with pneumatic equipment or
motor oil SAE 10-20, and insert the screw plug
back. Wrap some Teflon sealing tape around the
thread on the air connections. Screw the air con-
nections into the pneumatic devices.
z z
Starting up
Put on protective clothing and goggles.
OTHERWISE THERE IS DANGER OF INJURY!
Check that the parting disc has been tightened
securely.
Check that the workpiece is supported or has been
locked in place correctly. A C clamp is recom-
mended on loose workpieces.
Make sure that generated sparks do not pose any
danger, i.e. they cannot contact any persons or
ignite flammable substances.
Connect the compressed air supply. To do so, con-
nect the compressed air source to the compressed
air connection.
Press the switch ON guard towards the chuck.
Press the trigger arm, and perform the cutting work.
The device rotates at the maximum speed when the
trigger arm is tightened to the stop. Regulate the
tightening pressure and therefore the speed for the
optimal grinding results.
z z
Switching OFF
Release the trigger arm
2
to switch OFF the
pneumatic angle grinder.
After work, disconnect the device from the
compressed air source.
Note: First detach the hose from the compressed
air source, and then remove the supply hose from
the device. This prevents the supply hose from
whirling out of control.
z z
Maintenance
If the machine is to enjoy a long service life and
operate without problems, it is important that the
following maintenance instructions are followed.
The pneumatic angle grinder must be lubricated
regularly if it is to operate flawlessly at all times.
ATTENTION: DISCONNECT COMPRESSED AIR
BEFORE MAINTENANCE WORK!
Keep the pneumatic devices clean.
Turn over the tool so that the compressed air con-
nection points upwards, and apply a few drops of
pneumatic equipment or motor oil SAE 10-20 into
the compressed air connection on the pneumatic
devices.
Press the trigger arm 7 to distribute the oil more
evenly. Hold a cloth or absorbent paper towel in
front of the exhaust air openings, and let the device
run in idle mode for a few seconds.
ATTENTION! EXCESS OIL IS BLOWN OUT. KEEP
THE DISCHARGE HOLE AWAY FROM PERSONS
AND OBJECTS.
292193 Druckluft-Trennschleifer_content_LB6.indb 16 01.12.17 09:56