Parkside PDST 10 A1, Перевод оригинальной инструкции по эксплуатации и безопасности, Страница: 19 / 72

GB/IE/NI 19
Safety instructions for pneumatic tools / Operation
z „
Never transport the hose drum by
taking it by the hoses.
z „
Always hold the hose firmly
when you disconnect it from
the compressed air source or a
pneumatic tool.
z z
Residual risk
Even if you operate the device as
intended, there will be residual risks.
The following dangers may occur in
connection with the build and design
of this air-driven hose drum:
z „
Danger from beating compressed
air hoses.
z „
Danger of falling from com-
pressed air hoses lying around.
Reduce the residual risk by carefully
using the device as intended.
Operation
z z
Before starting up
z „
Take all parts from the packaging and check
whether the air-driven hose drum or parts show
any damage. If this is the case, do not use the
air-driven hose drum. Contact the manufacturer
via the indicated service address.
z „
Remove all protective films and other transport
packaging.
z „
Check that the delivery is complete.
z z
Mounting
Finding a mounting spot
z „
Mount the hose drum on a suitable ceiling or
wall; use of the unmounted hose drum is not
permitted.
z „
Choose a place for mounting the hose drum so
that it does not pose any obstacle.
z „
Ensure a mounting height of at least 2.5 metres
for ceiling installation.
z „
You need the following tools for mounting: a
power drill, a suitable drill bit and a wrench.
Mounting the hose drum
DANGER OF INJURY!
Improper mounting of the hose drum may cause
injury.
z „
Ensure that there are no lines or tubes at the
mounting site. Use a detector for this if neces-
sary or contact a specialist.
z „
Observe the safety notes for the drill used.
NOTE! Danger of damage!
Improper mounting may cause damage.
z „
Ensure that the carrier material at the mounting
site bears the weight of the hose drum. Contact
a specialist if you have any questions.
292166_Schlauchtrommel_content_LB8.indb 19 11.12.2017 13:36:10