Parkside PDFP 500 C3, Перевод оригинальной инструкции

Страница: 18 / 70

PDFP 500 C3
GB
│
IE
│ 15 ■
♦ Connect the compressed air hose with the
quick-action coupling to the compressed-air
connection on the appliance. The connection
locks automatically.
♦ Set the working pressure on the filter pressure
reducer of the compressed air source to 3 bar.
Preparing the surface
♦ Carefully cover a large area around the spray
surface. Any surface that is not masked could
become contaminated.
♦ Ensure that the spray surface is clean, dry and
free of grease.
♦ Polished surfaces should be lightly sanded and
the sanding dust removed.
Switching the appliance on/off
Working methods:
♦ Fit the filter in the gun (see fig. C).
♦ The vent must remain open while working.
♦ When thinning, ensure that the spray material
and the thinners are suitable for each other.
Using an unsuitable thinner can lead to the
formation of lumps which, in turn, can block the
spray gun.
♦ Screw the flow cup clockwise onto the spray
gun.
♦ Fill the flow cup with spray material and
close the lid .
♦ Hold the spray gun at a constant distance from
the object. The ideal spraying distance is ap-
prox. 15 cm.
♦ Work out the right settings by carrying out a test.
♦ Do not switch the appliance on/off over the
spray surface, rather start/end the spraying
process approx. 10 cm from the spray surface.
Switching on:
♦ To switch on, pull the trigger and keep it
pressed in.
Switching off:
♦ To stop working, simply release the trigger .
Setting the paint jet pattern
The appliance has two settings: round jet and
broad jet.
Round jet Broad jet
Setting the round jet:
■ Use the round jet for small surfaces, corners
and edges.
♦ Turn the control clockwise .
Setting the broad jet:
■ You can use the broad jet vertically or horizon-
tally for larger surfaces.
♦ Turn the control anticlockwise .
The nozzle head can be turned into any
position between the horizontal and the vertical.
Adjusting the paint flow
NOTE
► The front locking bolt is designed to limit the
adjustment range of the stroke limiter screw .
Increasing the paint flow:
♦ Turn the stroke limiter screw anticlockwise.
Decreasing the paint flow:
♦ Turn the stroke limiter screw clockwise.