Parkside PARKSIDE PPHSS 715, Инструкции по эксплуатации и безопасности

Страница: 7 / 10

Initial operation / Operation / Maintenance and cleaning / Disposal
9 GB/IE
j
Push the extractor connecting piece
U
into the
extractor channel
I
until it clicks into place.
j
Connect an approved system (e.g. vacuum
extractor) to the extractor connecting piece
U
to remove dust and chippings (see Fig. C).
L
Operation
L
Setting the cutting angle
j
Release the locking screw
{
with the Allen key
i
.
j
Set the cutting angle on the sole plate
O
using the
engraved markings 0° / 1° / 30° / 4° (left / right)
for mitre cuts. These values correspond to the
indentations for the cutting angle adjustment.The
housing has a retention pin
o
, (see Fig. B), which
must lock in place in the relevant indentations.
j
Tighten the locking screw
{
with the Allen key
i
after making the adjustment.
L
Setting the stroke rate
j
Set the required number of strokes on the
thumbwheel (speed selector)
R
.
j
Wherever possible, always determine the best
settings in a test run before starting work.
L
Setting the pendulum stroke
You can adjust the pendulum stroke of the saw blade
w
on the pendulum switch
}
. Working without pendulum
action (“0” position) produces fine and clean cut edges.
Switch the pendulum action off when working on
thin workpieces.
When the pendulum action is switched on (position
1 – 3), it is possible to work with increasing speed.
j
Wherever possible, always determine the best
settings in a test run before starting work.
L
Switching on / off
c Danger :
J
Make sure before connecting the tool to the
mains that the power supply is 230 V ~ 0 Hz
and is equipped with a 16 A fuse.
Switching on
j
Push the on-off switch
W
into “I” position until
it noticeably clicks into place.
Switching off
j
Push the on-off switch
W
into “0” position.
It returns into “0” position.
L
Maintenance and cleaning
L
Maintenance
j
Change the saw blade
w
as soon as the teeth
become blunt and it is no longer possible to
make a clean cut.
L
Cleaning
j
Always clean the tool directly after working with it.
j
Remove any dirt (e.g. caused by chippings) with
a dry, non-fluffing cloth.
L
Disposal
The packaging is made entirely of recyclable
materials, which you may dispose of at local
recycling facilities.
Do not dispose of electrical appliances
in household waste.
In accordance with European Directive 2002 / 96 / EC
on used electrical and electronic appliances and its
implementation in national law, used power tools
must be collected separately and recycled in an
ecologically compatible manner. Please return the
tool via the available collection facilities.