Parkside KH 3162 PNEUMATIC HAMMER DRILL, Инструкции по эксплуатации и безопасности

Страница: 7 / 10

L
Safety
Safety Information Specific
to this Device
J
For safety reasons this device may only be used
with the additional handgrip
O
.
J
When working with this device, hold it tightly
with both hands at all times. Ensure that you are
standing in a stable position.
J Caution:
Please ensure that the ventilation slits
are not covered during operation. Do not insert
any objects into the ventilation slits.
L
Using the Device
L
Operation
Note the mains voltage! The voltage of the mains
socket must match that shown on the rating plate
on the device (Devices marked with 230 V~ can also
be operated at 220 V~).
L
Assembling the Additional Handgrip
For safety reasons this device may only be used
when the additional handgrip
O
is correctly assembled
(see also Fig. D, E).
j
Attach the additional handgrip
O
to the spindle
neck and turn it in an anticlockwise direction
until it is tight.
L
Inserting / Removing Tools
Inserting a Tool
j
Before inserting the tool, apply a small amount
of grease to the tool holder
Q
.
j
In order to insert the tool, pull the locking / un-
locking cap
E
to the rear and insert the tool.
j
Release the locking / unlocking cap
E
. This
locks the tool holder in place.
Pull the tool to ensure that it is firmly locked in
place. The tool has some radial play inherent in
the system.
Removing a Tool
j
In order to remove the tool, pull the locking /
unlocking cap
E
to the rear.
L
quick action chuck for
round-shank drills
m Caution!
Do not use the round-shank drill for
hammer drilling or chiselling work!
Inserting the RÖHM Quick-Action Drill Chuck
for Round-Shank Drills
j
To insert the additional drill chuck for round-
shank drills (see also Fig. A), pull the locking /
unlocking cap
E
towards the rear and insert
the additional drill chuck.
j
Release the locking / unlocking cap
E
. This
locks the tool holder in place. Pull the tool to
ensure that it is firmly locked in place.
Removing the RÖHM Quick-Action Drill Chuck
for Round-Shank Drills
j
In order to remove the additional drill chuck, pull
the locking / unlocking cap
E
towards the rear
and take out the additional drill chuck.
Inserting Tools
m Caution!
Before making any modifications to
the device ensure that it is switched off and that the
mains plug has been removed from the socket.
The RÖHM quick-action drill chuck allows you to
change the tool quickly without any additional
implements.
Releasing the tool holder and inserting a tool
j
Hold the rear sleeve of the quick-action drill
chuck tightly and turn the front sleeve until it is
wide enough for the tool (e.g. round-shank drill)
to be inserted.
j
Then insert the tool.
Safety / Using the Device
9 GB/IE