Parkside 389213 2107, Руководство пользователя

Страница: 15 / 57

GB/IE/CY 15
the device is only connected to a supply with an Ssc short circuit
power which is larger or equal to 6106.5 W.
Note!
The device is only designed for use with a power supply where the
permissible mains Zmax impedance is equal to or below 0.225 Ω.
If you are in any doubt, then please contact an electrical professional.
z
Before using the device
Take the device and accessories out of the packaging and check them for damage (e.g. transport damage).
„
Connect the electrode holder
5
for MMA welding or the TIG torch for TIG welding to the welder.
„
Then connect the earth terminal
4
to the workpiece.
„
For MMA welding, place an electrode in the clamps of the electrode holder.
z
Using the device
z
MMA welding
„
Use electrode holder clamps without protruding bracket screws, which meet the current safety
standards.
„
Make sure that the ON/OFF switch
9
is set to position “O” (“OFF”) or that the mains cable
8
is
not connected to the socket.
„
Connect the welding cable according to its polarity and in accordance with the specifications of the
electrode manufacturer.
„
To do this, connect the connector of the earth terminal
4
with the relevant output on the inverter
welder (marked with “-”).
„
Connect the connector of the electrode holder
5
with the relevant output on the inverter welder
(marked with “+”).
„
Put on appropriate protective clothing in accordance with the specifications and prepare your
workplace.
„
Connect the earth terminal
4
to the workpiece.
„
Clamp the electrode into the electrode holder
5
.
„
Switch the device on by setting the ON/OFF switch
9
to the “I” (“ON”) position.
„
You can now set the welding current by rotating the control wheel
3
. By pressing the control button
2
several times, after selecting the “0.0” setting (in the “Electrode 1/6” menu item), you can choose
between the convenient functions: Hot Start, Arc Force and Anti Stick. You can set the parameters
using the control wheel
3
and confirm them by pressing the control button
2
.
„
By pressing the control button
2
until the “Electrode 1/6” menu item is displayed, you can select the
electrode thickness (1.6–4 mm) by rotating the control wheel
3
. The current and convenient
functions are then preset.
ATTENTION: Do not bring the earth terminal
4
and the electrode holder
5
/electrodes into direct
contact with one another.
ATTENTION: When welding with electrodes (MMA – manual metal arc welding – electrode
welding), the electrode holder
5
and the earth terminal
4
must be connected in accordance with the
specifications of the electrodes to plus (+) or minus (-).
„
Wear appropriate personal protective equipment and start the welding procedure.
„
To stop the procedure, set the ON/OFF switch
9
to the “O” (“OFF”) position.