Parkside 383216 2110, Инструкции по эксплуатации и безопасности

Страница: 11 / 36

10 GB/IE/NI
Operation
Nut
size
Applicable
material
thickness (mm)
Diameter of the hole
to be riveted (mm)
M5 0.5–2.5 7–7.5 (sheet steel)/8.0 (tubes)
M6 0.5–3.0 9–9.5 (sheet steel)/10.0 (tubes)
M8 0.5–3.5 11–11.5 (sheet steel)/12.0 (tubes)
M10 0.5–3.5 13–13.5 (sheet steel)/14.0 (tubes)
M12 0.5–3.5 15–15.5 (sheet steel)/16.0 (tubes)
Open the handle
8
and install the rivet nut onto the mandrel
1
(see Fig. M).
After installing, insert the rivet nut into the hole to be riveted
(see Fig. N).
Close the handle
8
to drive the nut into place (see Fig. O).
Turn the knob
7
anticlockwise to remove the hand riveter
(see Fig. P).
Troubleshooting
Open the handle
8
(see Fig. Q).
Loosen the nose piece
2
using the wrench
6
. To do this, turn
the wrench
6
anticlockwise (see Fig. R).
Push the slide sleeve
4
back and hold it in place (see Fig. S).
Turn the hand riveter anticlockwise and remove this (see Fig. T).
Place the wrench
6
on the mandrel
1
and turn it anticlockwise
to remove the mandrel
1
(see Fig. U).