Parkside 380745 2110, Перевод оригинальной инструкции

Страница: 11 / 165

PDSSA 20-Li A1
GB
│
IE
│ 7 ■
Before use
Charging the battery pack
(see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage
climate should be cool and dry and the
ambient temperature should be between 0°C
and 50°C.
♦ Connect the battery pack to the rapid
battery charger (see Fig. A).
♦ Insert the power plug into the socket. The
control LED lights up red.
♦ The green control LED indicates that the
charging process is complete and the battery
pack is ready.
CAUTION!
♦ If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦ Insert the battery pack back into the
appliance.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack
♦ Push the rotation direction switch into
the middle position (lock). Allow the battery
pack to click into the handle.
Removing the battery pack
♦ Press the release button and remove the
battery pack.
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in. The LED work
light lights up when the ON/OFF switch
is depressed lightly or fully. This allows for illumi-
nation of the work area in low lighting.
Switching off
♦ Release the ON/OFF switch to switch off the
appliance.
Setting the speed/tightening torque
♦ Press the ON/OFF switch lightly for a low
speed/tightening torque. Increasing the pressure
increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed and impact duration.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!