Parkside 373422 2104, Оригинальное руководство пользователя

Страница: 15 / 164

PTHSA 20-Li B3 ■ 10
│
GB
│
IE
Checking the battery charge level
♦ Press the battery charge level button
i
to
check the status of the battery (see also main
diagram). The status will be shown on the
battery display LED
u
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Inserting/removing the battery
pack
Inserting the battery pack
♦ Push the battery pack
r
into the handle until it
clicks into place.
Removing the battery pack
♦ Press the release button
t
and remove the
battery pack
r
.
WARNING! RISK OF INJURY!
► Before any work on the appliance, remove
the battery. Risk of electric shock!
Fixing/attaching the shoulder strap
♦ Hook the shoulder strap
e
into the carrying
lug
9
.
♦ Adjust the length of the shoulder strap
e
to
your size so that the carrying lug
9
is at hip
height when the strap is hooked in place.
Mounting the motor head on the
telescopic handle
♦ Undo the quick release
7
by pressing it in
the direction of the arrow . Pull out the
telescopic handle until the black plastic ring
is exposed.
♦ Place the lower end of the motor head
3
on
the upper end of the telescopic handle
6
so
that the motor head
3
can be pushed through
as far as the black plastic ring. Make sure that
the groove and the recess interlock with each
other.
♦ Tighten the red connecting piece
5
by turning
it towards the symbol on the motor head
3
.
Adjusting the telescopic handle
The telescopic handle
6
can be adjusted continu-
ously by means of the quick release
7
.
♦ Undo the quick release
7
by pressing it in the
direction of the arrow and adjust the
length by pushing or pulling as required.
♦ Close the quick release again
7
to fix the
desired working length of the telescopic
handle
6
.
♦ If the screws on the quick-release
7
have loos-
ened, tighten them again with the hex key
w
.
Adjusting the cutting angle
NOTE
► The cutting angle can be adjusted in 11
stages.
♦ Remove the battery pack
r
from the appliance.
♦ Press the release button
4
.
♦ Adjust the angle of the motor unit to the
required position.
♦ Let go of the release button
4
and the motor
unit will click into place.
♦ Insert the battery pack
r
back into the appli-
ance.
IB_373422_PTHSA20-LiB3_LB8.indb 10 18.11.2021 12:13:10