Parkside 373207 2104, Оригинальное руководство пользователя

Страница: 15 / 117

PDSS 310 B5
GB
│
CY
│ 11 ■
Use
Fitting a socket
WARNING! RISK OF INJURY!
► Disconnect the compressed air supply before
working on the tool .
♦ Push one of the supplied sockets
6
and/or the
extension attachment
7
onto the square socket
bit holder
1
.
Switching on/off
Switching on
♦ Press the trigger
5
to switch the tool on .
Switching off
♦ Release the trigger
5
.
♦ When you have finished working, disconnect
the tool from the compressed air source .
Setting the torque
♦ Press the torque control
4
and set the desired
torque range by turning it . Click the desired
level into place at the ◄ marker .
NOTE
► The torques which can be achieved depend
on the compressed air system installed .
Setting Torque
1 weak/minimum
2 normal
3 strong
4 very strong/maximum
Changing the direction of rotation
WARNING!
► The rotation direction switch
2
may only be
used/adjusted when the tool is at a standstill .
♦ Press the rotation direction switch
2
in the
direction "F" (Fasten) to set the clockwise rotation
mode . You can use this mode to tighten nuts, for
example .
♦ Press the rotation direction switch
2
in the
direction "R" (Release) to set the anticlockwise
rotation mode . You can use this mode to un-
fasten nuts, for example .
Maintenance and cleaning
WARNING! RISK OF INJURY!
Disconnect the tool from the
compressed air supply.
CAUTION!
► Before carrying out maintenance, clean off
any hazardous substances that may (due to
working processes) have accumulated on
the tool . Avoid all skin contact with these
substances . If the skin comes into contact
with hazardous dusts, this can lead to severe
dermatitis . If dust is produced or swirled up
during maintenance, it can be inhaled .
NOTE
► To ensure correct functioning and long-term
durability of the tool, pay attention to the
following points:
■ Sufficient and continuous oil lubrication is highly
important for optimum functionality .
■ Check the speed and vibration levels after each
use .
■ If the tool is exhibiting excessive vibration levels,
the cause of the vibrations must be identified
and dealt with .