Parkside 360432 2010, Инструкции по эксплуатации и безопасности

Страница: 21 / 101

21 GB/CY
Troubleshooting
Plasma burner 8
is not ready for
operation?

Current switch is switched off.

Air transmission is restricted.

Workpiece is not connected to
the ground terminal.

Switch the current switch to
“on”.

Another indication of this is
a green fl ame. Check the air
supply.

Check the connections.
Sparks fl y
upwards, instead
of down through
the material?

Burner sleeve 8c does not
penetrate the material.

Burner sleeve 8c is too far
away from the material.

Apparently material was not
grounded properly.

Lifting speed is too quick.

Increase the current.

Reduce the distance between
the burner sleeve
8c and
material.

Check the connection for
correct grounding.

Reduce the speed.
Initial cut but not
completely drilled
through?

Potential connection problem.

Check all connections.
Slag formation on
interfaces?

Tool/material creates heat.

Cutting speed too low or
current too high.

Plasma burner component
parts are worn
8b , 8c , 8d , 8e .

Allow the material to cool
down and then continue
cutting.

Increase the speed and/or
reduce the current until the
slag has been reduced to a
minimum.

Check and replace worn
parts.
Consumables
wear quickly?

Performance was
overstretched.

Arc control time exceeded.

Incorrect plasma burner
assembly.

Insuffi cient air supply,
pressure too low.

Faulty air compressor.

Material too thick, increase
the angle to avoid material
from being blown back into
the tip.

Do not control the arc for
more than 5 seconds. You can
also start with contact
between the burner sleeve
8c
and metal or with a 3.2 mm
distance to the metal.

Check the air fi lter, increase
the air pressure.

Check the performance of
the external air compressor
and make sure the pressure
is 4–4.5 bar.