Parkside 346192 2004, Оригинальное руководство пользователя

Страница: 26 / 105

PASSK 20-Li A1 ■ 22
│
GB
│
IE
Attaching/disconnecting the battery
pack to/from the appliance
Attaching the battery pack
♦ Push the rotation direction switch into the
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack
♦ Press the release button and remove the
battery pack .
Checking the battery charge level
♦ Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Use
Switching on and off
Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in.
The LED working light lights up when the
ON/OFF switch is depressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
♦ Release the ON/OFF switch to switch off the
appliance.
Setting/preselecting the rotation
speed/tightening torque
♦ Press the torque preselection button to select
the required torque in stages.
♦ Press the ON/OFF switch lightly for a low
speed/tightening torque. Increasing the pres-
sure increases the speed/tightening torque.
■ The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
► However, to tighten lug nuts, the smallest
torque setting must be selected to avoid over
tightening.
► The integrated motor brake ensures rapid
stoppage.
CAUTION!
♦ The tightening torque actually attained must
always be checked with a torque wrench!
Changing the direction of rotation
♦ Change the direction of rotation by pressing the
rotation direction switch towards the left or
right.
Fitting the socket
♦ Push one of the supplied sockets onto the
tool holder .
IB_346192_PASSK20-LiA1_LB8.indb 22 14.10.20 13:57