PWBS 180 B2
GB
│
MT
│
43
■
Sanding
■
Hold the appliance firmly with both hands
when working and ensure that you have
secure footing.
The appliance is guided more
safely with two hands.
♦
Connect your extraction system (internal or
external extraction).
♦
For external suction:
If possible, work with the remote switch-off or
the automatic start/stop function of the vacuum
cleaner. The vacuum cleaner switches on auto-
matically and switches off again after a time
delay in order to remove the remaining dust
from the suction hose.
♦
Switch on the appliance, place it with the entire
sanding surface on the surface you are working
on and move it over the workpiece with
moderate pressure.
♦
To prolong the service life of the accessory tool,
ensure that you apply even pressure.
♦
Use of excessive pressure does not lead to a
greater removal rate, but rather to increased
wear of the accessory tool.
♦
Lift the appliance off the working surface.
♦
For internal extraction:
Let the power tool run for a few more seconds
to remove the remaining dust from the suction
hose .
Sanding close to the edge
If you are sanding close to the edge, you can
remove a hood segment of the protective and
suction hood . This means that the accessory tool
you are using is closer to floor, wall and ceiling
edges as well as existing installations such as
pipes, and the adjacent surfaces can be precisely
machined.
Expect dust to develop during this work, as the
protective and suction hood is no longer closed
off.
♦
Pull the hood segment forwards out of the
protective and suction hood .
♦
Work the surfaces close to the edge.
♦
Push the hood segment back into the suction
hood until it locks into place.
