Parkside 332964 1907, Перевод оригинальной инструкции

Страница: 25 / 92

PPMA 20-Li A1 ■ 20
│
GB
│
IE
Mounting the polishing hoods
ATTENTION!
► Make sure you remove the battery pack
before fitting or removing the polishing
hoods / .
♦ Turn the appliance over so that the polishing
disc is facing upwards.
♦ Fit one of the polishing hoods / on the
polishing disc . Make sure that the polishing
hood is centred and taut on the polishing disc .
Use
Wear safety goggles!
Setting the rotational speed
♦ Adjust the speed adjustment wheel to a
position between 1 and 6.
Polishing
■ Use the synthetic polishing hood for
dewaxing or polishing.
■ Use the terry cloth polishing hood for
applying polish.
♦ Apply some polish to the attached polishing
hood / and the workpiece.
♦ Manually spread the polish over the surface
you want to polish.
NOTE
► Do not apply the polish to the same surface
too often, as the particles it contains could
damage the finish.
► Mask any plastic components beforehand
as these could be faded by the polish.
♦ Set the On/Off switch to the "I" position.
♦ Guide the appliance across the workpiece
parallel to its surface.
♦ Move the appliance parallel and evenly over
the surface being polished.
♦ Do not press the appliance down. Pressing
down hard does not increases the working
efficiency.
♦ When you are satisfied with the result, turn
off the appliance. To do this, set the On/Off
switch to the "0" position.
ATTENTION!
► Depending on the size and nature of the
workpiece, suitable safety precautions must
be taken. Use suitable clamps to prevent the
workpiece from slipping.
Working procedures
■ Apply minimal pressure when working.
■ Work at a constant speed.
■ Carry out the polishing process parallel to the
surface and overlap the polishing strokes.
■ After completing the task, lift the appliance
from the workpiece and then switch it off.
Maintenance and cleaning
WARNING!
► Always disconnect the battery pack
before carrying out any work on the
appliance.
The appliance is maintenance-free.
■ Always clean the appliance directly after
completion of work.
■ Use a dry cloth to clean the housing.
■ Remove any sanding dust stuck to the appliance
with a brush.
■ Never use sharp objects, petrol, solvents or
cleaning agents which can damage plastic.
Do not allow any liquids to get into the interior
of the appliance.
■ If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level is
between 50% and 80%. The optimum storage
environment is cool and dry.
IB_332964_PPMA20-LiA1_LB8.indb 20 02.03.20 09:18