8
GB
Safety instructions
Prior to each use, check that
it is working properly by
pressing the “Test” button.
The product is not suitable for
laser welding.
The product is only approved
for use within a temperature
range of between -5 °C to
+55 °C.
The product is not fire-resistant.
Welding helmet and UV filter
must not be exposed to any
heat or moisture.
Do not remove the ADF filter
from the welding helmet and
never open the housing of the
ADF filter without authorisation
from the manufacturer.
Prior to each use, check
whether the Welding/Grinding
setting was selected correctly.
The viewing pane must be
installed on the outer side of
the ADF filter. Otherwise, the
ADF filter can get damaged.
Do not carry out any modifi-
cations/replacements on the
welding helmet and ADF filter
without consent.
If the filter does not darken
automatically whilst welding
please stop the operation
immediately and contact the
dealers without delay.
Do not use any alcohol, fuel
or diluting agents to clean the
ADF filter. Do not place the
ADF filter in water.
The response time of the ADF
liquid crystal slows down if the
ambient temperature is lower,
however this does not have
an impact on the protective
functions.
Please replace the housing
of the ADF filter immediately
if it is damaged or scratched
because this can impair
visibility and the protective
performance.
Please replace the viewing
pane immediately if it is bro-
ken or scratched. Do not use
any hard objects to replace the
viewing pane of the filter.
Regularly clean the surfaces
of the ADF filter, sensor and
solar cells.
The welding helmet cannot
withstand any damages that
are caused by a heavy blow,
explosion or abrasive liquids.
The useful life depends on
many different individual
factors such as usage, clean-
ing, storage and maintenance.
Regular inspections and
replacement in the case of
damage are recommended.
The material used to manufac-
ture the product will age
over time. This can result in