PWSA 20-Li B3
■
62
│
GB
│
MT
e)
Always use an undamaged clamping flange
of the correct size and shape for the selected
grinding disc.
Suitable flanges support the
grinding disc and reduce the risk of disc break-
age. Flanges for cutting discs can be different to
flanges for other grinding discs.
f)
Do not use worn grinding discs from larger
power tools.
Grinding discs for larger power
tools are not designed for the higher rotational
speeds of smaller power tools and can break.
Additional special safety instructions
for abrasive cutting
a)
Avoid any blockage to the cutting disc or
high contact pressure. Do not make any ex-
cessively deep cuts.
Overloading the cutting
disc increases the stress and likelihood of tilting
or jamming and thus the possibility of kickback
or breakage of the grinding tool.
b)
Avoid the area in front of and behind the rotat-
ing cutting disc.
When you move the cutting
disc away from yourself in the workpiece, it is
possible, in the event of a kickback, that the
power tool along with the rotating disc might be
thrown out directly towards you.
b)
If the cutting disc jams or you stop working,
switch the tool off and hold it steadily in
the workpiece until the disc has completely
stopped turning. Never attempt to pull a
rotating cutting disc out of a cut. This could
lead to kickback.
Identify and remove the
cause of the jam.
d)
Do not switch the power tool back on while
it is located in the workpiece. Allow the cut-
ting disc to reach its full speed before you
carefully continue the cut.
Otherwise, the disc
can jam, jump out of the workpiece or cause
kickback.
e)
Support boards or large workpieces to reduce
the risk of the cutting disc jamming and caus-
ing a kickback.
Large workpieces can bend
under their own weight. The workpiece must be
supported on both sides of the disc: both in the
vicinity of the cutting disc and also at the edge.
f)
Be particularly careful when making pocket
cuts into existing walls or other obscured ar-
eas.
The inserted cutting disc may cut into gas
or water pipes, electrical wiring or other objects
that can cause kickback.
Safety guidelines for battery chargers
■
This appliance may be used by chil-
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks. Do not allow
children to use the appliance as a
toy. Cleaning and user maintenance
tasks may not be carried out by chil-
dren unless they are supervised.
■
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for indoor use
only.
WARNING!
■
To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
ATTENTION!
♦
This charger can only charge the following bat-
teries: PAP 20 A1 / PAP 20 A2 / PAP 20 A3.
♦
A current list of battery compatibility can be
found at www.lidl.de/Akku.
