25
GB/IE
Crossed lines can be locked with this product:
When the product is performing automatic levelling and the base
of the measurement device deviates from the horizontal by less than
4° (green LED on) hold down the H-button
1
until the LED indica-
tor
2
goes red. Now automatic levelling is switched off and the
crossed lines are permanently switched on - even if the base of the
measurement device deviates from the horizontal by more than 4°.
You can turn this mode off again by pressing and holding down the
H-button
1
until the LED indicator
2
goes green again. The auto-
matic levelling system has been switched on again.
The crossed lines are turned off as soon as the base of the measuring tool
deviates from the horizontal by more than 4°, and the LED indicator
2
will turn red again.
Working without the automatic
levelling system
Put the LOCK switch
4
into the position .
Hold down the H-button
1
until the red LED indicator
2
comes
on. Now the product will release two laser lines from the laser
beam opening
7
that are not levelled. Operation without automatic
levelling will always be indicated via the red LED indicator
2
.
Practical guidance
Always use only the middle of the laser line for markings. The width
of the line depends on the distance.
Working with the tripod
Setup and alignment
1. Pull all the three legs
17
of the tripod apart. The plastic ring
15
,
which is connecting all the three cross hinges will be moved to the
end of the middle column.
2. Release the blocking levers
16
and extend the legs until you get
your desired height.
3. Then, fold-back all those blocking levers
16
.
4. Check the straight positioning by using the bubble level
11
. If the
tripod is straight, the air bubble will be positioned in the centre of
the circle. If necessary, readjust the length of the legs
17
.
Содержание 322432-1901
Страница 3: ...H V 1 2 7 8 10 1 1a 11 13 14 15 12 16 17 18 19 9 3 4 5a 6 A...
Страница 4: ...C 5a 1 2 B 6 5...
