Parkside 309823, Инструкции по эксплуатации и безопасности

Страница: 46 / 198

46 GB/IE
Press "Return / Clear" button
8
multiple times to go back to
Home-screen (see Home-screen part for more detail).
Note: Pressing "Return / Clear" button
8
under continuous
measurement mode will stop the measurement.
Selection of the reference point
The rear reference point (base) or the end piece reference point or
the front reference point of the device can be used as the contact
surface for any measurement. The reference point is to be set before
measurement. Otherwise, the measured result differs from actual
value. The default reference point setting is from the rear side of
the device. The reference point can be changed by pressing the
reference button
12
repeatedly until the desired reference point
shown on the top left side corner of the display.
End piece reference point
End piece
33
will be useful while a distance is measured from a
corner (diagonal room) or from the place, where it is difficult to
reach. End piece
33
is located on the rear side of the device. The
End piece
33
can be unfolded as shown in the fig D using a sharp
tool or finger nail. Once finished using, the End piece
33
has to be
folded-back for future use.