Parkside 285816, Инструкции по эксплуатации и безопасности

Страница: 7 / 27

8 GB/IE/NI
When removing the hose cou-
pling, hold the hose firmly in your
hand to prevent injuries caused
by the hose springing back.
Watch out for damage. Check
the product for damage before
first use. If the product shows de-
ficiencies, it cannot be operated
in any circumstances.
The product may only be oper-
ated using cleaned, oil-free and
condensate-free compressed air.
CAUTION! RISK OF INJURY!
Keep children and other people
away from the product during use.
You could lose control of the
product if you are distracted.
Be attentive while working! Pay
attention to what you are doing.
Proceed with caution.
Avoid uncomfortable positions.
Make sure that you are standing
firmly and that your weight is
evenly balanced.
Wear suitable working clothes.
Wear tight-fitting clothing, non-slip
shoes, a hairnet, or tie back your
hair. Jewellery or loose-fitting
clothing can get stuck in moving
parts of the product.
Keep your workplace clean.
Disorder can lead to accidents.
Do not use the product in a damp
or wet environment.
Every person in
the direct vicinity
of the work environment must
wear protective goggles and
earmuffs.
Remove the product from the com-
pressed air source before repair
and maintenance work and be-
fore transport.
Do not carry the compressed air
device by the hose, but by the
housing instead.
Do not kink the compressed air
hose. This could cause damage.
NOTE!
Please observe all manu-
facturer’s instructions regarding
inflatable articles.
Use
Note: please remove all packaging material from
the product.
Note: seal all male threads on the pneumatic
accessories with teflon tape.
Connect with compressor
(A) Connect a quick coupling
2
with one end of
the pneumatic hose
1
; connect the other end
with a quick plug nipple
3
. Then insert the
quick plug nipple
3
into the quick coupling
on the compressor.
(B) Connect a quick plug nipple
4
with the pneu-
matic device. Then plug the quick plug nipple
4
that is connected to the pneumatic device into
the quick coupling
2
that is connected with
the pneumatic hose. The pneumatic device is
now ready for use.