Parkside Performance 329780 2001, Перевод оригинальной инструкции

Страница: 11 / 61

PDSSAP 20-Li A1
GB
│
IE
│
NI
│
7
■
Safety guidelines for battery chargers
■
This appliance may be used by chil-
dren aged 8 years and above and
by persons with limited physical,
sensory or mental capabilities or
lack of experience and knowledge,
provided that they are under super-
vision or have been told how to use
the appliance safely and are aware
of the potential risks. Do not allow
children to play with the appliance.
Do not allow children to carry out
cleaning and user maintenance
tasks unless they are supervised.
■
To avoid potential risks, damaged
mains cables should be replaced
by the manufacturer, their customer
service department or a similarly
qualified person.
The charger is suitable for indoor use only.
WARNING!
■ To avoid potential risks, damaged mains
cables should be replaced by the manufac-
turer, their customer service department or a
similarly qualified person.
ATTENTION!
♦ This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦ A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
► Never charge the battery pack if the ambient
temperature is below 10°C or above 40°C.
If a lithium-ion battery is to be stored for an
extended period, the charge level should be
checked regularly. The optimum charge level
is between 50% and 80%. The storage climate
should be cool and dry, and the ambient
temperature should be between 0°C and
50°C.
♦ Insert the battery pack into the high-speed
charger (see fig. A).
♦ Insert the power plug into the socket. The
control LED
! lights up red.
♦ The green control LED
.
indicates that
charging is complete and the battery pack
is ready for use.
ATTENTION!
♦ If the red control LED
!
flashes, this means
that the battery pack has overheated and
cannot be charged.
♦ If the red and green control LEDs
!.
both
flash, this means that the battery pack is
defective.
♦ Push the battery pack into the tool.
♦ Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains power
socket.
IB_329780_PDSSAP20-LiA1_LB6.indb 7 07.08.20 13:58