Parkside Performance 322701 1901, Инструкции по эксплуатации и безопасности, Страница: 37 / 132

36 GB/IE
¾
Before operating the product, check whether
the accessory tool is correctly positioned, i.e.
centred in the chuck 1 .
¾
Screw bits are labelled according to their
dimensions and their shape. If you are
uncertain, always check whether the bit fits
tightly in the screw head without any free
play.
˜
Working instructions
Torque
¾
Smaller screws/bits can be damaged if you
set the torque or rotational speed too high.
Hard screw joints (in metal)
¾
Particularly high torque occurs, for example
in metal screw joints made using drive
sockets. Select a low rotational speed.
Soft screw joints (e.g. in soft wood)
¾
Again, use a low rotational speed, e.g. to
avoid damaging the surface of the wood
upon contact with the screw head. Use a
countersink.
Drilling in wood, metal and other
materials
¾
Use a high speed for drill bits with small
diameter and a low speed for drill bits with
large diameter.
¾
Select a low speed for hard materials and a
high speed for soft materials.
¾
Secure or fasten the workpiece in a clamp or
vice (if possible).
¾
Mark the spot where you want to drill
using a centre punch or nail. Select a low
rotational speed when starting.
¾
Pull the rotating drill bit from the hole
repeatedly to remove dust and chips and
clear the hole.
Drilling in metal
¾
Use a metal drill (HSS). For optimum results,
cool the drill bit with cooling lubricant
(cutting oil). Metal drill bits can also be
used to drill into plastics. Start with a 3 mm
diameter drill bit and then increase the size
until the desired hole diameter is achieved.
Drilling in wood
¾
Use a wood drill with a lathe centre.
Deep holes: Use an auger bit.
Large-diameter holes: Use a Forstner bit.
Small screws can be screwed directly into
soft wood.
Belt clip
m
CAUTION! RISK OF INJURY!
u
Before hanging the product in the belt:
Push the rotation direction switch 5 to
the centre position (lock). This prevents
the product from being switched on
accidentally.
¾
The belt clip 9 allows the tool to be hooked
on belt or pocket.
˜
Cleaning and care
m
WARNING!
Always switch the product off, remove
the battery pack 10 and let the
product cool down before performing
inspection, maintenance and cleaning
work!