FITTING
Check First
Before drilling holes with the provided hole cutter check for the following.
1. Make sure no filler has been used on the bumper, this can cause install issues.
2. Make sure no crash bar is directly behind the hole you plan to drill and you have enough space behind
the cut hole for the sensor and cable so as not to over bend the cable or force the cable against any
metal.
Sensor Fitting
1. Use masking tape to protect the bumper and allow for easy marking of the sensor positions.
2. Cut the hole with the provided hole cutter letting the cutter do the work, do not put pressure on the
cutter as the centre drill could fail and cause damage to the bumper.
3. Remove any swarf from the hole and make sure the sensor fits okay neither being too tight or too
loose.
4. Locate the sensor in the up position, (there is a mark on the back of the sensor showing the up
position) and install into the bumper.
5. When securing cables do not crush with a cable tie or bend too tightly as this will effect the operation
of the sensors.
6. Leave some slack to allow for sensor removal if needed at a later date.
Control Box Fitting
Fix securely in a suitable location away from moisture allowing for access to the connectors. Ideally all
connectors should face down.
Buzzer Fitting
Fix securely in a suitable location away from moisture, ideally in a position where it is not covered for
maximum volume.
How To Use Collars
Page 1
