Parkray CONSORT 15 Скачать руководство пользователя страница 20

Страница: 20 / 40

Extended Burning (Solid Mineral Fuel)

The stove can be banked up for extended burning. When burning solid fuel, empty the ashpan. Open air controls and
let the fire burn brightly for a short period. Refuel and close both air controls, the exact setting required will depend
on the fuel used and the chimney draw so some practice may be necessary.

To revive the fire, open the air controls until the fire is burning brightly de-ash if necessary and refuel. Set air
controls as required.

Never leave the stove unattended until you are certain that the flames are fully established.
Should the fire fail to light correctly

open the door and use a poker to spread the fuel across the bottom of the

firebox. Close the door and allow the fuel and stove to cool before attempting to relight the fire.

Notes on Woodburning

With a full load of wood, the stove will need to be refuelled approximately once every hour.  Wood can be stacked in
the stove, but care must be taken that logs do not touch the baffle.  Overloading the stove can cause excess smoke
to be emitted. Wood burns most efficiently with the secondary air valve lever in the open position and the primary
control closed. Moving the secondary control will control the burn rate of the stove.
Note - primary and secondary air is needed to light the stove, see section en

titled ‘Lighting the Stove’

Wood burns most efficiently on a bed of ash and it is therefore only necessary to remove surplus ash from the stove
occasionally.

If there is insufficient burning material in the fire bed to light a new fuel charge, excessive smoke emission can occur.

Refuelling must be carried out with a sufficient quantity of glowing embers and ash, so that the new fuel charge will
ignite quickly. If there are too few

embers, add some kindling to prevent excessive smoke.

Maximum Log Length:
See Technical Specification

Ensure your logs are well seasoned with a moisture content of less than 20%

Reduced Combustion

In order to shut down the stove, close the primary control, then close the secondary air slider by moving the handle
all the way to the left. If the controls are left in this position, the fire will be starved of air and will die down.
If you want to revive the fire it is recommended that the primary air control is open first, and then open the
secondary air slider.

Warning! -

The stove will remain

hot

for a considerable time after the fire has been

extinguished.

Refuelling

Refuelling must be carried out with a sufficient quantity of glowing embers and ash, so that the new fuel charge will
ignite quickly. If there are too few embers, add some kindling to prevent excessive fuel. The air controls should not
need adjusting while refuelling. (When refuelling it is important to have a damper in the open position if you have
one.)

Recommended Fuels

Hunter Stoves Group recommend that only wood logs with a moisture content of less than 20% and anthracite or a
manufactured briquette smokeless fuel which is suitable for closed door appliances are used on this appliance.
Burning wet or unseasoned wood will create excess smoke emissions, tar deposits in the stove and chimney and will
not produce a satisfactory heat output.

Only authorised fuels may be used in UK smoke control areas.

A list of authorised fuels can be found at -

http://uksmokecontrolareas.co.uk/fuels.php

WARNING - DO NOT BURN BITUMINOUS COAL, PETRO-COKE, OTHER PETROLEUM BASED FUELS OR TREATED
WOOD SUCH AS PALLETS AS THIS WILL INVALIDATE THE PRODUCT WARRANTY. HOUSEHOLD WASTE MUST NOT
BE BURNT ON THIS APPLIANCE.

A list of approved fuels can be found at: - HETAS Ltd

–

Telephone 01242 673257

–

http://hetas.co.uk/public/hetas_guide.html

Solid Fuel Association

–

Telephone 0800 600 000

–

www.solidfuel.co.uk