ASSEMBLY
The carry handle and orange driveshaft section of pole is supplied pre-attached to the Engine & Gearbox mountings.
The Black extension part of the driveshaft slides inside the end of the orange driveshaft section as shown. Ensure the
correct end of the black extension shaft is inserted into the orange driveshaft.
To ensure the black drive shaft pole is correctly positioned, attach the chainsaw head to the other end of the black
extension drive shaft ensuring the locating screw screws into the hole at the end of the pole.
With the engine sitting upright on a flat surface locate the black extension pole inside the orange driveshaft lining up the
inside cable rod so that it slides inside the black extension pole. It may be necessary to twist the black extension pole to
the left and right to locate the cable rod. Slide the black extension pole inside the orange driveshaft approximately half a
meter.
Locate the plastic locking section around the orange driveshaft and around the black extension pole and secure using the
supplied Securing Bolts and Nuts. Adjust the desired length of the pole and lock into position with the plastic locking
Handle.