9.
CHECKING LID SHUT-OFF DEVICE
1. Lift the lid.
2.
Turn one hotplate burner tap to its full on position and push the ignition button.
3.
Close lid. There should now be no gas supply to the hotplate and the burner will go out.
4.
Turn off the hotplate tap and lift the lid. The gas supply should now be restored to the hotplate. When the
tap is turned on.
10. CHECKING THE OVEN
1.
Turn the oven thermostat to Mk.9 and check that there is sparking from the ignition system. This should
continue until the oven burner is alight.
2..
When the oven burner lights up the sparking should cease, there should be a low gas rate at first to the
oven burner which is the flame supervision device (F.S.D.) by pass rate.
3.
When the F.S.D. phial has heated up it opens the F.S.D. valve and the main gas stream flows to the
burner.
4.
After 1 minute check that the flame covers the full width of the burner and is stable.
5.
Set the oven thermostat to Mk.2, close the oven door and check that after about 10 minutes the flame
has reduced in size.
6.
Turn off the thermostat and check that the oven flames go out.
11. TO SET THE TIME OF DAY
To set the clock (See Fig. 10).
1
Turn on electricity supply and ensure that the
thermostat is in the off position.
2
Press buttons 1 and 2 together.
3.
Release the buttons and within 5 seconds
press button 2. The display will read 12:00.
4
Within 5 seconds set the time of day by
pressing and holding either button 1 to
decrease or button 2 to increase the time.
NOTE: that it is a 24 hour clock.
12. MINUTE MINDER OPERATION
Having set the clock up as described above, to set
the minute minder press and release button 1 then press and hold button 2 until the display shows the
required time interval.
The clock will count up in one minute intervals until the desired time is reached. If necessary, press button 1
to achieve the correct time interval. The bell symbol will show in the display.
The minute minder will begin to count down once set. At the end of the time period, the minute minder will
sound for up to 2 minutes and the bell symbol will flash and show the time of day.
To stop the sound, press button 1. The display will stop flashing and show the time of day, e.g. 9·00. The bell
symbol will go out.
To cancel the minute minder press and release button 1. Then press and hold button 1 until 0 ·00 shows in
the display. Release button 1, to reset the time of day press buttons 1 and 2 together.
GENERAL NOTE
Instruct the user on how to use the appliance and its ignition system. Refer the user to the wording in the
inside cover which gives advice on the safe operation of the appliance.
R G 5 5 G L - 311528701
FIG.10
