Parker TS8000 Series, Начало работы, Страница: 11 / 32

Installation And Power TS8000 Getting Started
Page 8 http://www.SSDdrives.com
Installation And Power
The following specifications pertain to the TS8000 series HMI. SSD Drives retains the
right to modify specifications at any time, without prior notice.
Mounting Instructions
This operator interface is designed for through-panel mounting. A panel cutout
diagram and a template are provided. Care should be taken to remove any
loose material from the mounting cut-out to prevent it from falling into the
operator interface during installation. A gasket is provided to enable sealing to
NEMA 4X/IP66 specifications. Install the provided nuts and tighten evenly for
uniform gasket compression. For more Detailed documentation, refer to
“Appendix A, B, C, D, and E – Mounting Templates”.
Connecting To Ground
This protective conductor terminal is bonded to conductive parts of the
equipment for safety purposes and must be connected to an external protective
grounding system.
Each TS8000 has a chassis ground terminal on the back of the unit.
The unit should be connected to ground. The chassis ground is not
connected to the signal common of the unit. Maintaining isolation
between the ground and the signal common is not required to
operate the unit, however, other equipment connected to this unit may require
isolation between the ground and the signal common. To maintain isolation
between signal common and ground, care must be taken when connections are
made to the unit. For example, a power supply with isolation between its signal
common and ground must be used. Also, plugging in a USB cable may connect
signal common to ground.
Power Supply Requirements
The TS8000 series requires a 24vdc power supply, rated at 9.5W (TS8003), 14W
(TS8006), 24W (TS8008), 33W (TS8010) or 67W (TS8015). The units may draw
considerably less than the rated power depending upon the options being used.
As additional features are used, the unit will draw increasing amounts of power.
Items that could cause increases are: additional communications, optional
communications cards, use of the CompactFlash card, and other features
programmed through DSI8000.
In any case, it is very important that the power supply is mounted correctly if the
unit is to operate reliably. Please take care to observe the following points:
• The power supply must be mounted close to the unit, with usually not
more than 6 feet (1.8 m) of cable between the supply and the operator
interface. Ideally, the shortest length possible should be used.